BMW E30
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. The engine
+ 3.1.2. Specifications
+ 3.2. Dismantle and engine major repairs
- 3.3. An engine electric equipment
3.3.2. Specifications
3.3.3. The battery - engine start-up in emergency situations
3.3.4. Removal and battery installation
3.3.5. Power cables
+ 3.3.6. Ignition system
+ 3.3.7. System of a charge of the battery
+ 3.3.8. System of start-up of the engine
3.3.9. Malfunctions of the generator
3.3.10. The basic malfunctions of an electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
+ 11. A running gear
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice
|
Check
| PERFORMANCE ORDER |
| 1. Periodically check cables on all length, damage, растрескивание or the burn-out of isolation of cables, and also corrosion are not supposed. Unreliable connection of the battery can cause refusals at engine start-up, and also deterioration of operational qualities of the engine. |
| 2. Check up a condition of connections of poles with plugs, presence on them corrosion, cracks and easing of fastening of wires. Presence of a white shelled touch under isolation in a plug place testifies to corrosion of conductors of a cable and necessity of its replacement. Check up presence of corrosion and deformations on plugs and a condition of bolts of fastening. |
|
Replacement
| PERFORMANCE ORDER |
| 1. Disconnect from the battery old cables, track packing of cables on their length and find places of their fastening to a starter and to weight, disconnect cables from the traction relay of a starter and weight. Remember a route of a lining of a cable to lay a new cable to the place of the replaced. |
| 2. If cables are replaced new getting new cables, grasp with itself old. New cables should correspond in accuracy to the replaced. The cable of a positive pole is easy for distinguishing from a cable negative – isolation of a cable of a positive pole of usually red colour, these cables have большее cross-section section, the storage plug differs in the big diameter. Isolation of a cable of connection with weight of black colour, cross-section section and diameter of the plug is less, than at a cable of a positive pole. |
| 3. Clear carvings of fastening of cables of the battery on the traction relay of a starter and on a body, remove corrosion traces. |
| 4. Attach a cable to the traction relay of a starter or to weight, reliably tighten nuts and fastening bolts. |
| 5. Before joining to the battery of a new cable be convinced that the cable has sufficient length, and will be established without a tension. |
|
|
On the main page
|