BMW 3 series E30

Since 1983-1994 of release

Repair and car operation

BMW E30
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
- 11. A running gear
   11.1.10. Back springs
   11.1.11. A bar of the back stabilizer of cross-section stability
   11.1.12. Levers of a back suspension bracket
   11.1.13. Bearings of back wheels
   11.1.14. Corners of installation of wheels
   11.1.2. Specifications
   11.1.3. The stabilizer of cross-section stability of a forward suspension bracket
   11.1.4. The suspension bracket lever
   11.1.5. A rack of a forward suspension bracket
   11.1.6. Springs or the shock-absorber of a rack of a suspension bracket
   11.1.7. Spherical support
   11.1.8. A nave of a forward wheel and the bearing
   11.1.9. Back shock-absorbers
   + 11.2. A steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice

11. A running gear

11.1. Suspension brackets

11.1.1. Introduction

THE GENERAL DATA

The prevention
Repair of details of a suspension bracket by welding or рихтовкой is forbidden. Погнутые or the failed details are subject to replacement. Number under the catalogue of a new detail should correspond to number of the replaced.

Forward suspension bracket and steering (a kind from outside the bottoms)

1. A cross-beam
2. The stabilizer of cross-section stability
3. A rack of the stabilizer of cross-section stability
4. The suspension bracket lever
5. A rack
6. A tip of steering draught
7. The steering mechanism

Forward suspension bracket independent type the Poppy-ferson. Suspension bracket racks fasten in the top part to the strengthened sites of wheel niches and to suspension bracket levers in the bottom part. The stabilizer of cross-section stability fastens to a cross-beam of a suspension bracket and to suspension bracket levers through racks.

General view of a forward suspension bracket

1. The top fastening of a rack of a suspension bracket
2. A stabilizer rack
Cross-section stability
3. Steering draught
4. The suspension bracket lever
5, 7. Spherical опра the suspension bracket lever
6. The steering mechanism
8. A cover
9. A tip of steering draught
10. A suspension bracket rack

Back suspension bracket

1. The shock-absorber
2. A spring
3. Полуось 4. The lever
5. The holder of a reducer of a back axis
6. The stabilizer of cross-section stability

Back suspension bracket lever, with springs and shock-absorbers. The shock-absorber in the top part fastens to a body, and in the bottom part – to the suspension bracket lever. The stabilizer of cross-section stability fastens to suspension bracket levers through racks and collars to a body.

General view of a back suspension bracket

1. The shock-absorber
2. The stabilizer of cross-section stability
3. A reducer (the main transfer and differential)
4. An internal SHRUS
5. A back support of a reducer
6. Covers of SHRUS
7. The suspension bracket lever
8. Fastening of the lever of a suspension bracket
9. A cross-beam of a back axis
10. A spring

On the main page