BMW 3 series E30

Since 1983-1994 of release

Repair and car operation

8.1.3. A check point control lever

THE GENERAL DATA

The mechanism of management of a check point

1. A cover 2. The top section of the lever 3, 6, 7, 35. A spring ring 4. A rubber holder 5, 8. A washer 9. A spring 10. For the stamped case of the mechanism 11. The bearing (for the stamped case) or Persistent ring (for the cast case) 12. The bottom lever 13, 27. Back fastening of the case of the mechanism Check point managements 14. Алюминевая a cast column of switching Transfers 15. A nut 16, 28. Draught 17. Скоба 18, 29. The plug

19, 33. A ring 20, 32. A pin 21, 30. To ползуну a check point 22, 31. A felt epiploon 23, 36. A clamp 24, 40. The bottom bearing 25. Conducting of a signal of a backing 26. Скоба conductings 34. A remote washer 37. Forward fastening of the case of switching of speeds 38. A nut 39. The shtampovyj case of switching of speeds 41. A sound-proof lining

Removal and installation

PERFORMANCE ORDER

1. Include back speed, lift car redock. 2. Remove the lever handle. 3. Remove a cover and sound-proof stuffing. 4. Remove an internal cover, preliminary having disconnected a socket of the switch of a signal of a backing. 5. Remove скобу (1) and disconnect the lever (2) from draught of a check point (3). 6. On cars with the steel stamped case of the mechanism of management of a check point remove a lock ring of the hinge and remove the lever. 7. On cars with a cast aluminium column of a gear change turn a lock ring of the bearing of the lever a special key (or having rested 2 screw-drivers) on 1/4 turns and get the lever. 8. Installation is carried out upside-down. On cars with an aluminium column of a gear change combine a teeth on a plastic lock ring with grooves in a column and press a ring before click.