Audi 100/A6

1990-1997 of release

Repair and car operation

2.1.1. Introduction

THE GENERAL DATA

Impellent compartment of models with petrol 20-klapannym the engine in volume of 1,8 l

1. A cover of a jellied mouth of oil 2. The air filter 3. The fuel filter 4. Vrhnee fastening of a rack of a forward suspension bracket 5. A tank of a brake liquid 6. The gauge of a stream of air 7. An inlet collector 8. Щуп for check of level of oil

9. The broad block of system of cooling 10. A tank of system of the hydraulic booster of a steering 11. A tank of a washing liquid 12. The generator 13. A directing roller 14. Module ABS

The bottom view of an impellent compartment of models with petrol 20-klapannym the engine in volume of 1,8 l

1. A reception pipe of an exhaust system 2. The bottom lever of a forward suspension bracket 3. The stabilizer of cross-section stability of a forward suspension bracket 4. A brake support

5. Small horns of a sound signal 6. The lever of fastening of the engine 7. Заглушка a drain aperture of the oil pallet

The bottom view of a back part of a body

1. The intermediate muffler 2. The longitudinal lever of a back suspension bracket 3. A rope of a manual brake

4. A rack of a back suspension bracket and a spring 5. A back axis 6. Cross-section draught

This section is intended to help the motorist to support the car in good repair, to reduce the fuel and oil expense and to prolong car service life.

In section the general plan of maintenance service of the car with detailed transfer of operations of maintenance service is resulted.

Maintenance service carrying out according to the resulted plan of maintenance service will provide long and reliable service of the car. This plan of maintenance service is full, therefore it is recommended to perform all operations of maintenance service at the appointed time.

At service of the car you will notice that some operations can be combined with carrying out of other operations is follows from essence of operations of maintenance service. For example, if you have lifted the car for carrying out of any operation elements of system of release of the fulfilled gases can be checked up simultaneously with check of elements of a suspension bracket or a steering.

Before the work beginning it is necessary to be prepared for maintenance service carrying out. Read all description of operation which you are going to execute, and get necessary tools and spare parts. If you have faced a serious problem, address to experts.

	Volumes
	Models with the 4-cylinder engine	Models with the 5-cylinder engine	Models with the 6-cylinder engine
Engine oil (including the filter)	3,0 l	4,5 l	5,0/5,5 l
Cooling system	7,0 l	8,0 l	9,0 l

Transmission:
– A mechanical transmission	2,4 l
– An automatic transmission:
• total amount	5,5 l
• liquid replacement	3,5 l
• the main transfer of an automatic transmission	1,0 l
System of the hydraulic booster of a steering:
– Models with automatically adjustable back suspension bracket	2,5 l
– Models with a usual back suspension bracket	1,1 l
Fuel tank:
– All models (approximately)	80 l
The engine:
– The oil filter:
• models with engine ADR coding, ABK, AAE, AAD, AAR	Champion C160
• models with the coding of the engine to ASYA	Champion C149
• models with engine AAN coding, ABC, ACK	Champion
• models with engine AAN coding	Champion
Cooling system:
– The antifreeze maintenance:
• 40 % the antifreeze maintenance	Protection to–25 ° With
• 50 % the antifreeze maintenance	Protection to–35 ° With
The power supply system:
– The air filter	Champion U572
– The fuel filter	The fuel filter
Ignition system:
– A corner of an advancing of ignition:
• engine ADR	It is supervised by a control system of engine work
• engines AAE, ASYA, АВК and AAD	6°±1 ° to ВМТ
• engine AAR	15°±1 ° to ВМТ
• engine AAN, AAH, ACK	It is supervised by a control system of engine work
• engine ABC	7 °–27 ° to ВМТ
Spark plugs:
– Models with engine ADR coding, ABK, AAD, AAR	Champion N7BYC
– Models with the coding of the engine to ASYA	Champion C6BYC
– Models with engine AAE coding	NGK BUR6ET
– Models with engine AAN coding	Bosch F5DPOR
– Models with engine ABC coding, AAH, ACK	NGK BKUR6ET-10
Spark backlash of spark plugs:
All models	0,8 mm
Brake system:
– Is minimum admissible thickness of a frictional material of brake overlays of forward brakes	2,0 mm
– Is minimum admissible thickness of brake overlays of back brakes	7 mm
– Is minimum admissible thickness of a frictional material brake колодок back brakes	2,5 mm
Privodnoj belt:
– A deviation:
• new приводной a generator belt	2,0 mm
• приводной the belt of the generator which was in operation	5,0 mm
• приводной a belt of the pump of system of the hydraulic booster of a steering	10,0 mm
• приводной a belt of the compressor of the conditioner	5,0 mm

The inhaling moments, Н.м.

Fixing bolt of the generator	35
Fastening натяжителя the generator	20
Fastening nut натяжителя the generator	35
Nut of fastening of a jellied tube of an automatic transmission (097)	80
Заглушка a jellied aperture / of an aperture for check of level of a liquid of an automatic transmission	25
Заглушка a viewing aperture of an automatic transmission (01N)	15
Perepusknaja tube of an automatic transmission (01N)	2
Заглушка a jellied aperture / of an aperture for check of level of oil of a mechanical transmission:
– A transmission 012	25
– A transmission 01Е	40
Fastening of the pump of system of the hydraulic booster of a steering	25
Bolts of fastening of wheels	110
Spark plugs:
– Models with engine ADR coding, ААЕ, ABK	30
– Models with the coding of the engine to ASYA, AAD, AAR	20
– Models with engine AAN coding	20
– Models with engine ABC coding, AAH, ACK	30
Заглушка a drain aperture of the oil pallet	30