Audi 100/A6

1990-1997 of release

Repair and car operation


Audi 100/A6
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 3.2. Diesel engines
- 3.3. Removal and a partition of engines
   + 3.3.2. Technical characteristics
   3.3.3. Repair work, possible without engine dismantle
   + 3.3.4. Major repairs
   3.3.5. Removal and engine installation
   3.3.6. An engine partition
   + 3.3.7. A head of cylinders
   3.3.8. Pistons and rods
   + 3.3.9. A cranked shaft
   3.3.10. An intermediate shaft
   3.3.11. The block of cylinders
   3.3.12. Radical bearings and bearings of rods
   3.3.13. Piston rings
   3.3.14. The first start of the engine after a partition
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, a steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice

3.3. Removal and a partition of engines

3.3.1. Introduction
THE GENERAL DATA
The prevention

All designs except 6-cylinder petrol engines are described.

In present subsection operations on engine major repairs, including details of a head of the block of cylinders and the block of cylinders are considered. In subsection are included as the recommendations concerning as the organisation and preparation of works on major repairs of the engine, purchase of spare parts, and the detailed description of procedures of dismantle and installation of details of the engine, and also methods of check of a technical condition of details.

In the subsequent subsections it is meant that repair work is spent after dismantle of the power unit from the car.

The specifications resulted above are necessary only for check of a technical condition of details in procedures of repair described more low.


On the main page