Audi 100

1982-1990 of release

Repair and car operation




Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
+ 3. Engines
- 4. Cooling system
   4.1. Replacement of a cooling liquid
   4.2. Replacement and thermostat check
   4.3. Removal and installation of the water pump
   4.4. Check and replacement of the gauge of inclusion of the electrofan
   4.5. Replacement of the gauge of temperature of a cooling liquid
   4.6. Removal and installation of a radiator of system of cooling
+ 5. An exhaust system
+ 6. The power supply system
+ 7. Transmission
+ 8. A running gear
+ 9. A steering
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment

4.6. Removal and installation of a radiator of system of cooling
PERFORMANCE ORDER
1. To disconnect a wire from "the minus" plug of the accumulator.
2. To merge cooling liquid (subsection 4.1 subitem 1-3 see).
3. To disconnect bringing (3) (fig. System of cooling of the 4-cylinder engine see) or (20) (fig. System of cooling of the 5-cylinder engine see) and taking away (9) or (13) hoses of a radiator.
4. To disconnect a hose going from a broad tank to a radiator, to remove a tank.
5. To disconnect conducting from the engine of the fan, the gauge of temperature of a cooling liquid and the gauge of inclusion of the fan.
6. To turn on from below bolts of fastening of a radiator.
7. To turn away bolts of fastening of the top casing 22 or 9 radiators and to remove it.
8. To turn away bolts of fastening of a radiator from above and a nut from below approximately in the middle if it is.
9. To take out a radiator with a casing of the fan and the fan upwards.
10. To establish a radiator upside-down. Before radiator installation to check up and if are worn out to replace rubber plugs of fastening of a radiator and the buffer. At installation of a casing of a radiator to track, that the cable of a drive of the lock of a cowl has passed through a corresponding aperture.


On the main page