Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation

Тойота 4Раннер
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
- 6. Transmissions
   - 6.1. A mechanical transmission
      6.1.1. Specifications
      6.1.2. A back epiploon of a check point (on rear-wheel cars)
      6.1.3. Support картера a check point
      6.1.4. A check point control lever
      6.1.5. Removal and manual transmission installation
   + 6.2. Automatic transmission
   + 6.3. A distributing box
+ 7. Transmission elements
+ 8. Brake system
+ 9. A suspension bracket and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes

6.1.4. A check point control lever

Removal and installation

1. Remove the central section of the forward panel (subsection 10.24 see).
2. Turn away the lever handle (a photo at the left). Turn away 4 screws (are shown by arrows on a photo on the right), remove a cover and a flange.
3. On a part of cars 4WD covers of both levers fasten one flange.
4. Remove a small cover of the lever of a check point (a photo at the left). On some check points press the lever, turn counter-clockwise (a photo on the right).
5. Remove the lever.
6. Installation is carried out upside-down. Grease rubbing surfaces of the lever консистентной with greasing.

On the main page