| 1. Disconnect the battery from weight. |
| 2. Remove the lever. |
| 3. On rear-wheel cars remove engine N2 guard. On cars 4WD remove both guards. |
| 4. Disconnect карданный () a shaft (). |
| 5. Remove a forward exhaust pipe. |
|
|
| 6. Disconnect a cable or a speedometer socket (a photo at the left). Disconnect a socket of the switch of a backing (a photo on the right). |
|
7. Disconnect wires of the gauge of oxygen, for this purpose turn away a bolt of an arm of a plait, disconnect other wires on картере a check point. The part of plaits is connected by the sockets strengthened in the top part of transmission.
|
| |
8. These plaits are necessary for disuniting and taking aside. |
| 9. On cars 4WD disconnect sockets from a distributing box. |
| 10. Disconnect the working cylinder of coupling. |
|
11. Turn away bolts картера couplings (are shown by arrows). Carter of coupling on the car "Toyota 4 Runner/Hilux/Surf" from check point W59 fastens 4 bolts and 2 nuts (2WD and 4WD), on check point R150 (F) – 4 bolts. |
| 12. Prop up a check point the cart – a jack. |
| 13. Establish under the pallet of the engine a jack. |
| 14. Remove a back cross-beam, having turned away 4 through bolts and 4 nuts. |
| 15. Remove support картера a check point. |
| 16. Remove a starter. |
|
|
| 17. Turn away 6 bolts on check point R150 (F) (drawing at the left) or 3 bolts on check point W59, крепящих a check point to the engine (drawing on the right, except starter bolts (1)). |
| 18. Be convinced that all necessary wires are disconnected, and displace a check point back so that the primary shaft of a check point left coupling or картера couplings. On cars 2WD it is required to turn a check point on 90 ° clockwise, again to displace back, to lower a check point and to get from under the car. On cars 4WD displace a check point with a distributing box downwards and back. |
| 19. On cars 4WD remove from a check point a support and a distributing box. |
| 20. Examine coupling details. |