Audi 100/A6

1990-1997 of release

Repair and car operation


Audi 100/A6
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
- 3.2. Diesel engines
   - 3.2.1.2. Technical characteristics
      3.2.1.3. Sinhronizatsionnye labels timing
      3.2.1.4. Compression check
      3.2.1.5. A gazoraspredelitelnyj belt
      3.2.1.6. Натяжитель газораспределительного a belt, an asterisk
      3.2.1.7. Additional приводные belts
      3.2.1.8. A camshaft cover
      3.2.1.9. A camshaft epiploon
      3.2.1.10. An epiploon of an intermediate shaft
      3.2.1.11. Epiploons of a cranked shaft
      3.2.1.12. A head of cylinders
      3.2.1.13. Hydraulic pushers
      3.2.1.14. A flywheel
      3.2.1.15. Engine fastenings
      3.2.1.16. The oil pallet
      3.2.1.17. The oil pump and маслозаборный a branch pipe
   + 3.2.2. 5-cylinder engines
+ 3.3. Removal and a partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, a steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice

3.2.1.6. Натяжитель газораспределительного a belt, an asterisk

NATJAZHITEL ГАЗОРАСПРЕДЕЛИТЕЛЬНОГО OF THE BELT

Removal
PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator.
2. Remove приводные belts.
3. Establish piston N1 in ВМТ and remove the top cover газораспределительного a belt.
4. Loosen the a nut натяжителя and ослабьте a belt. Braid a nut.
5. Remove натяжитель.

Installation

PERFORMANCE ORDER
Establish натяжитель upside-down and pull a belt.

CAMSHAFT ASTERISK

Removal

PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator.
2. Remove приводные belts.
3. Establish piston N1 in ВМТ and remove the top cover газораспределительного a belt.
4. Remove натяжитель and a belt.
5. Unscrew a bolt of an asterisk of a cranked shaft and remove an asterisk.

Installation

Installation is spent upside-down removals.

ASTERISK OF THE CRANKED SHAFT

Removal
PERFORMANCE ORDER
1. Remove газораспределительный a belt.
2. Unscrew a bolt of an asterisk of a cranked shaft and remove an asterisk.

Installation

Installation is spent upside-down removals.

PERFORMANCE ORDER
1. Insert a bolt of an asterisk of a cranked shaft.
2. Tighten a bolt till the demanded moment of an inhaling.
3. Tighten a bolt on a demanded corner.

ASTERISK OF THE INTERMEDIATE SHAFT

Removal

PERFORMANCE ORDER
1. Remove газораспределительный a belt.
2. Stop an asterisk and unscrew a bolt. Remove an asterisk.

Installation

Installation is spent upside-down removals.


On the main page