Audi 100/A6

1990-1997 of release

Repair and car operation


Audi 100/A6
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and a partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
- 6. Fuel system
   - 6.1.2. Technical characteristics
      6.1.3. The air filter and branch pipes of a fence of air
      6.1.4. A regulator of temperature of arriving air
      6.1.5. An accelerator rope
      6.1.6. Elements of system of injection of fuel
      6.1.7. The fuel filter
      6.1.8. The fuel pump and the gauge of level of fuel
      6.1.9. A fuel tank
      6.1.10. Release of pressure from system of injection of fuel
      6.1.11. An inlet collector
      6.1.12. Check of system of injection of fuel
      6.1.13. Neetilirovannyj gasoline
   + 6.2. Multidot system of injection of fuel
   + 6.3. System of injection MPI/MPFI (6-cylinder engines)
   + 6.4. The power supply system of diesel engines
   6.5. The device of service of heating
   6.6. Diagnostics of malfunctions of system of heating
   6.7. The conditioner: not only "pluses", but also "minuses"
   6.8. Rules of service of the conditioner
+ 7. An exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, a steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice

6.1.5. An accelerator rope Removal
PERFORMANCE ORDER
1. Disconnect a rope from an axis throttle заслонки.
2. Remove a braid of a rope from a fixing arm.
3. Remove the furnish panel under a steering column.
4. Disconnect a rope from a pedal of an accelerator and remove a rope.

Installation

Installation is spent upside-down removals.

Adjustment

MODELS WITH THE MECHANICAL TRANSMISSION
PERFORMANCE ORDER
Adjust position of a metal clip on a rope braid that at completely squeezed out pedal of an accelerator throttle заслонка it was completely open.

MODELS WITH THE AUTOMATIC TRANSMISSION
PERFORMANCE ORDER

Establish the block, in the thickness of 9 mm between a pedal of gas and a floor and press a pedal to the block. Adjust position of a braid of a rope on the case throttle заслонки so that throttle заслонка it was completely open. Check up work of the switch of fall of transfer.


On the main page