Audi 100

1982-1990 of release

Repair and car operation




Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. An exhaust system
+ 6. The power supply system
- 7. Transmission
   - 7.1. Coupling
      7.1.1. A technical characteristics
      7.1.2. Coupling removal
      7.1.3. Survey and дефектовка coupling details
      7.1.4. Coupling installation
   + 7.2. A mechanical drive of deenergizing of coupling
   + 7.3. A hydraulic drive
   + 7.4. A transmission
   + 7.5. A drive of forward wheels
+ 8. A running gear
+ 9. A steering
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment

7.1.3. Survey and дефектовка coupling details
PERFORMANCE ORDER
1. To clear of a dust and a dirt press and conducted disks, and also a working surface of a flywheel.
2. To examine a conducted disk. Cracks on details of a conducted disk are not supposed. To check up deterioration of frictional overlays. In a case if heads of rivets are deepened on distance less than 0,2 mm, a surface of frictional overlays is made oily or weakened заклепочные connections (or frictional overlays) it is necessary to replace a conducted disk. To check up reliability of fixing демпферных springs in nests of a nave of a conducted disk, at the broken springs it is necessary to replace a disk. To check up palpation of a conducted disk if at visual survey it is revealed it коробление. If palpation exceeds 0,4 mm (it is measured on distance of 2,5 mm from an external edge of a disk), it is necessary to replace a disk.
3. To examine working surfaces of a friction of a flywheel and a press disk, having paid attention to absence deep рисок, надиров, забоин, obvious wear tracks and an overheat. Easing заклепочных connections of details of a press disk is not supposed. In the presence of the specified defects it is recommended to replace knots. To check up коробление a press disk, having put a metal ruler to its working surface. If probe in the thickness of 0,3 mm can be inserted in any place under a ruler to replace press a disk with a casing in gathering.
4. External survey to estimate a condition диафрагменной springs of a press disk. Places of contact of petals of a spring with the bearing of deenergizing of coupling should be in one plane and not have obvious wear tracks.
5. To check up ease of moving in an axial direction of a conducted disk of coupling on шлицам a primary shaft. At the complicated moving to remove agnails with шлицов. Radial люфт a disk on a shaft it is not supposed.


On the main page