Audi 80/90/Coupe

Since 1986-1991 of release

Repair and car operation

8.1.3. Press a coupling disk

THE GENERAL DATA

The coupling device

1. A coupling disk The casing of springs is turned to a press disk 2. A flywheel Check up adjusting pins On a surface of a friction of overlays of coupling there should not be scratches, oils or greasings Use the tool 10-201 for installation removal /

3. A bolt, 30 Н.м. + 1/4 (90 °) a turn The additional quarter (90 °) a turn can be carried out in two stages on 45 ° Always replace a bolt: DO NOT USE REPEATEDLY Cover a carving of a new bolt with fixing structure 4. Press a disk 5. 25 Н.м.

Replacement

PERFORMANCE ORDER

1) fix a flywheel 2) oslabte/clamp bolts in regular intervals and on a diagonal; use directing tool And = 3176 3) reinstall the holder 10-201 in the course of a tightening of bolts The prevention Press the disk should contact completely with a flywheel before installation of assembly bolts. 4) for coupling repair remove a transmission The prevention Press disks and coupling disks have a corrosion-resistant coating, therefore it is necessary to clear only rubbing surfaces. Otherwise service life of disks will considerably be reduced. 5) do not apply efforts at installation of a press disk since it is possible to damage adjusting pins / of an aperture

Check

PERFORMANCE ORDER

1) check up about cracks, burning and deterioration traces 2) maximum internal конусность: 0.3 mm 3) check up overlays and шлицы about deterioration, and a rivet – about rigidity 4) check up the ends of springs of a diaphragm (are specified by arrows) 5) as much as possible admissible deterioration: to half of spring The prevention In need of replacement choose press a disk and a coupling disk under the catalogue of spare parts, using an alphabetic code and engine number.