Audi 80/Avant
+ The description
+ Engines
+ System of release of the fulfilled gases
+ Cooling system
+ Fuel tank and the fuel pump
+ The air filter and воздухозаборные channels
+ Injection system
+ Coupling
- Transmission and transmission
Removal and installation of a mechanical transmission (КП)
Noise in a transmission
Automatic transmission (АКП)
Electronic control АКП
The main transfer
Power shafts
Check of cuffs of power shafts
The list of malfunctions
+ Suspension bracket and steering
+ Brake system
+ Antiblocking system of brakes
+ Wheels and tyres
+ Kuzovnaja electrosystem
+ Ignition system
+ Illumination
+ Signalling devices
+ Devices and auxiliary devices
+ Heating and ventilation
+ Body elements
+ Search of malfunctions
+ Specifications
|
Removal and installation of a mechanical transmission (КП)
|
|
Removal of a mechanical transmission. Behind КП it is suspended only on one traverse (marksman) which is necessary for removing completely. |
Front-wheel models
The car is necessary for lifting and fixing so that you could work both in a motor compartment, and under the car bottom. КП acts in film in a direction downwards.
|
|
- To remove a wire of connection with "weight" of the accumulator.
- To remove three top bolts, connecting the engine and КП.
- To turn off a wire connecting to a body — "weight" КП.
- To remove the tip of the gauge of turns on КП; for this purpose to wring out tip clips. The same to repeat with the tip to the switch of headlights of a backing.
- To weaken conducting bandages, to separate plug connection to a ljambda-probe.
- To disconnect the bottom panel of a motor compartment (the head body Elements).
- To disconnect a forward exhaust pipe from a collector, and also каталитический neutralizer from the middle (basic) muffler. To remove a corresponding part of the muffler.
- To remove back to a traverse.
- To remove a rod of a plug of gear change КП.
- To disconnect from КП system cables procon-ten.
- To remove protective sheet of a leading semiaxis.
- To remove leading semiaxes on the right and to the left of КП, to turn away hinges in a direction to the left (holding thus the ends of shaft) and to tie up both leaders of a semiaxis.
- To remove the working cylinder of a hydraulic drive of coupling; the pipeline can remain connected.
- To prop up the top end the helmsman сошки.
- To protect the engine supports from overturning forward or back.
- To bring from below under КП a garage jack.
- To remove КП and a forward support of the engine.
- To turn out the bottom bolts connecting the engine and КП.
- Cautiously to wring out КП from the engine by means of mount.
- Now on a jack cautiously to lower КП.
- For installation to clear шлицевое connection of primary shaft КП and to grease with paste MoS2 or консистентной greasing V.A.G. G 000 100.
- To check, whether for centering КП directing plugs have entered into the block of cylinders of the engine.
- To check up and if necessary to adjust a gear change at established КП.
- Models with the 6-cylinder engine: to bring картер КП at the left above at an angle 30 °, palpation on an exhaust pipe differently is possible.
- The inhaling moments look in the table.
|
|
The inhaling moments
|
The inhaling moment
|
Н•м
|
|
КП to the engine
|
|
M 8
M 10
M 12
|
25
45
65
|
|
Power shaft to a shaft with a flange
|
|
M 8
|
45
|
|
On the main page
|