BMW 3 series E30

Since 1983-1994 of release

Repair and car operation

11.1.12. Levers of a back suspension bracket Removal and installation

PERFORMANCE ORDER

1. Block forward wheels. Lift a back part of the car and establish on supports, remove wheels. 2. Remove карданный a shaft, or disconnect a shaft from a reducer flange. 3. Disconnect a back hose of a brake from a tube on an arm of the back lever. A hose and a tube muffle. 4. Disconnect a cable of a manual brake (subsection 10.10 see). 5. Disconnect the bottom fastening of the shock-absorber, lower the lever. 6. Turn away a nut of axes of the lever, remove axes and remove the lever. 7. Check up a condition of plugs of axes. In case of detection of cracks, hardenings of rubber or plug anguishes replace, having handed over the lever in a workshop. Diameter of the plug on the one hand is slightly more, this part is designated by a fillet. The party with the big diameter should be turned on the internal lever towards the central part of the car, and on the external lever – from the car. 8. Assemblage is carried out upside-down. At assemblage raise the lever a jack that симитировать real height in the conditions of driving, and tighten nuts of axes with the set moment. Upon termination of remove air from brakes.