BMW 3 series E30

Since 1983-1994 of release

Repair and car operation


BMW E30
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
- 11. A running gear
   11.1.10. Back springs
   11.1.11. A bar of the back stabilizer of cross-section stability
   11.1.12. Levers of a back suspension bracket
   11.1.13. Bearings of back wheels
   11.1.14. Corners of installation of wheels
   11.1.2. Specifications
   11.1.3. The stabilizer of cross-section stability of a forward suspension bracket
   11.1.4. The suspension bracket lever
   11.1.5. A rack of a forward suspension bracket
   11.1.6. Springs or the shock-absorber of a rack of a suspension bracket
   11.1.7. Spherical support
   11.1.8. A nave of a forward wheel and the bearing
   11.1.9. Back shock-absorbers
   + 11.2. A steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice

11.1.5. A rack of a forward suspension bracket
THE GENERAL DATA
The prevention

Suspension bracket racks are recommended to be changed simultaneously.

Cнятие and installation

PERFORMANCE ORDER
1. Release bolts of forward wheels.
2. Lift car redock.
3. Remove a wheel.
4. Disconnect from the rack case all hoses and wires.
5. Disconnect ABS-system sockets (if are provided).
6. At removal of the left rack disconnect a socket of the gauge of deterioration колодок.

7. Turn away a bolt of fastening of the gauge of ABS-system (if it is provided), remove a brake disk, preliminary having removed a support (see subsection 10.4) (bolts of fastening of a support of a brake are specified by arrows).

8. Remove a brake board.

9. Disconnect the stabilizer of cross-section stability from a stabilizer rack, having turned away a fastening nut (it is specified by an arrow).

10. Disconnect a spherical support of the lever of a suspension bracket from a rotary fist (arrows are specified самоподжимные nuts of fastening of a spherical support and a tip of steering draught).
11. Disconnect steering draught.
12. Take away the bottom part of the case of a rack from the suspension bracket lever.
13. Turn away 3 nuts of the top fastening of a rack from outside a motor compartment. Preliminary establish under a rack a prop.
14. Remove a rack. The replacement procedure of the shock-absorber of a rack see in subsection 11.1.6.
15. Installation is carried out upside-down. Replace all самоподжимные nuts on fingers of spherical support, a tip of steering draught and on the top fastening of a rack of a suspension bracket. Tighten all connections with the moments specified in subsection 11.1.2.
16. After assemblage check up and adjust corners of installation of wheels in car-care centre.


On the main page