BMW 3 series E30

Since 1983-1994 of release

Repair and car operation

BMW E30
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. The engine
   + 3.1.2. Specifications
   + 3.2. Dismantle and engine major repairs
   - 3.3. An engine electric equipment
      3.3.2. Specifications
      3.3.3. The battery - engine start-up in emergency situations
      3.3.4. Removal and battery installation
      3.3.5. Power cables
      - 3.3.6. Ignition system
         3.3.6.2. Check of system of ignition
         3.3.6.3. Check and installation of the moment of ignition (only for system TCI)
         3.3.6.4. The ignition distributor
         3.3.6.5. The ignition coil
         3.3.6.6. The shaper of impulses and the block of electronic ignition
         3.3.6.7. A backlash in the gauge of the shaper (system TCI)
         3.3.6.8. Gauges of system of ignition
      + 3.3.7. System of a charge of the battery
      + 3.3.8. System of start-up of the engine
      3.3.9. Malfunctions of the generator
      3.3.10. The basic malfunctions of an electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
+ 11. A running gear
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice

3.3.6.4. The ignition distributor

THE GENERAL DATA

The distributor of system of ignition TCI

1. A vlagozashchitnyj cap external

2. A vlagozashchitnyj cap internal

3. A distributor cover

4. The dustproof screen

6. A spring ring

7. A pin

8. A plate of a rotor of the shaper of impulses

9. The shaper of impulses

10. A socket of the shaper of impulses

11. The distributor case

12. A vacuum regulator

13. A spring ring

Бегунок, a dustproof cover and a sealing ring of the distributor of ignition of system DME

Removal and installation of the distributor of ignition – system TCI

PERFORMANCE ORDER

1. Designate and disconnect from the wire distributor. For a detachment of wires remove caps of the distributor of ignition, having hooked in the specified places and having separated parts.

2. Turn out a candle from 1st cylinder.

3. Expose the piston of 1st cylinder in ВМТ a compression step (subsection 3.1.4 see).

4. Designate and disconnect from the distributor vacuum hoses.

5. Put a label on the case of the distributor opposite to the index бегунка and designate labels position of the distributor concerning the engine.

6. Turn away a nut (bolt) of a collar.

7. Remove the distributor.

The prevention
Turn коленвала after distributor removal is not supposed.

8. Installation is carried out upside-down. Be preliminary convinced that the piston of 1st cylinder is exposed in ВМТ a compression step. Insert the distributor so that the put labels were combined, at installation the shaft gear wheel should turn. Check up installation of the moment of ignition.

Removal and installation of the distributor of ignition – system Motronic

PERFORMANCE ORDER

1. Turn away bolts, remove a cap and a distributor cover.

2. Turn away 3 screws and remove бегунок from the platen.

3. Installation is carried out upside-down.

On the main page