BMW 3 series E30

Since 1983-1994 of release

Repair and car operation

BMW E30
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Cooling system
+ 5. Heating and ventilation
- 6. Fuel system
   6.2. Specifications
   6.3. Check of system of injection
   6.4. A measuring instrument of a stream of air
   6.5. A throttle branch pipe
   6.6. A regulator of pressure of fuel
   6.7. An atomizer of start-up of the cold engine and a thermotimer
   6.8. Check and replacement of atomizers
   6.9. The air proof-reader of idling
   6.10. An order декомпрессии fuel system
   6.11. Check of pressure of fuel
   6.12. The fuel pump, the pump of pumping and the gauge of level of fuel in a tank
   6.13. Gasoline pipe lines and the union
   6.14. A fuel tank
   6.15. The air filter
   6.16. A cable of a drive throttle заслонки
   6.17. The carburettor
+ 7. An exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
+ 11. A running gear
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice

6.14. A fuel tank
Removal

PERFORMANCE ORDER

1. Devastate a tank a trip or through a drain stopper. Turn away a stopper of a mouth of a tank to remove residual pressure. Disconnect the battery from weight.

2. Turn out a drain stopper of a tank and merge the gasoline rests. If the stopper is not provided, merge gasoline through a hose with a rubber pear.

3. Disconnect from a tank a conducting socket, hoses of gasoline pipe lines and from a tank with an absorber. On a part of cars for this purpose it is required to remove a back seat.

4. Remove a tank guard.

5. Disconnect a jellied mouth and a ventilating hose

6. Lift a back part of the car and establish on supports. On a part of cars remove an exhaust system and карданный a shaft.

7. Establish under a tank the cart with a jack and prop up a tank through a board.

8. Turn away fastening bolts on corners (marksman).

9. Disconnect bolts of fastening of a coupling tape of a tank and take aside.

10. Lower a tank so that it was possible to be convinced that all is disconnected.

11. Remove a tank.

12. Installation is carried out upside-down.

Repair

Tank repair is carried out by skilled experts. Independently to repair a tank the soldering or welding it is forbidden.

On the main page