BMW 3 series E30

Since 1983-1994 of release

Repair and car operation


BMW E30
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Cooling system
+ 5. Heating and ventilation
- 6. Fuel system
   6.2. Specifications
   6.3. Check of system of injection
   6.4. A measuring instrument of a stream of air
   6.5. A throttle branch pipe
   6.6. A regulator of pressure of fuel
   6.7. An atomizer of start-up of the cold engine and a thermotimer
   6.8. Check and replacement of atomizers
   6.9. The air proof-reader of idling
   6.10. An order декомпрессии fuel system
   6.11. Check of pressure of fuel
   6.12. The fuel pump, the pump of pumping and the gauge of level of fuel in a tank
   6.13. Gasoline pipe lines and the union
   6.14. A fuel tank
   6.15. The air filter
   6.16. A cable of a drive throttle заслонки
   6.17. The carburettor
+ 7. An exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
+ 11. A running gear
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice

6.16. A cable of a drive throttle заслонки

Check

PERFORMANCE ORDER
1. Remove an air cleaner from a throttle branch pipe (on инжекторных engines) or the air filter (carburettor engines).
2. Be convinced that by pressing a pedal заслонка opens completely and it is closed at release pedals.
3. Заслонка should not touch the case, otherwise replace a throttle branch pipe in gathering.

Adjustment

PERFORMANCE ORDER
1. Warm up the engine and stop. Press an accelerator pedal to the full twice and check up a cable free wheeling on the carburettor (a throttle branch pipe).
2. If the cable free wheeling does not correspond to norm adjust, rotating a nut (), keeping a nut ().

Replacement

Procedure for инжекторных engines, procedure for carburettor engines differs nothing.

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. Release adjusting nuts of a cable and get a cable from a cover arm on a soaking up collector.
3. Compress a plastic clamp and push it in an arm groove.
4. Turn дросельную заслонку and remove a cable through cut in an arm.
5. Remove a cable from an arm, remove a plastic clamp.
6. Disconnect a cable from an accelerator pedal.
7. Stretch a cable through a partition from outside a motor compartment.
8. Installation is carried out upside-down. Adjust a cable.


On the main page