Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation



Тойота 4Раннер
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
- 4. Systems of heating, ventilation
   4.1. Specifications
   4.2. Antifreeze
   4.3. The thermostat
   4.4. Крыльчатка the fan and гидромуфта
   4.5. A radiator and a tank
   4.6. Маслоохладитель
   + 4.7. The pump
   4.8. The gauge of temperature of a liquid
   4.9. The electric motor and a chain of the fan of a heater
   4.10. A heater radiator
   4.11. The control panel the air-conditioning block
   + 4.12. A central air
   4.13. The compressor
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. A suspension bracket and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes





4.8. The gauge of temperature of a liquid
THE GENERAL DATA

The location of the gauge of temperature on 4-cylinder engines

1. The temperature gauge

2. The gauge of pressure of oil

The temperature gauge on engine V6 of 3,0 l

1. The temperature gauge

2. The gauge of pressure of oil

The temperature gauge on engine V6 of 3,4 l

1. The temperature gauge

2. The gauge of pressure of oil

Check

PERFORMANCE ORDER
1. If the index does not register temperature check up safety locks.
2. If the gauge shows a condition "Hot" ("hot") right after start-up of the cold engine disconnect a wire from the gauge. If the indication falls, the gauge replace. If the indication remains overestimated the reasons can be short circuit on weight of a wire of the gauge, or malfunction of the index.
3. If the gauge ceases to show temperature after full warming up of the engine (after approximately 10 minutes after start-up), and safety locks are serviceable, arrive as follows. Stop the engine, disconnect a wire from the gauge and a wire piece close a gauge wire on well cleared site of the engine. Include for short time ignition but the engine do not start. If the index shows now "Hot" the gauge replace.
4. If gauge indications are absent, breakage in a chain (subsection 11.18 see), or malfunction of the index can be the reason.

Replacement

PERFORMANCE ORDER
1. Disconnect a wire from the gauge.
2. Screw the gauge and turn new, reliably tighten. Attach a wire.
3. Believe liquid level.

On the main page