Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation

4.9. The electric motor and a chain of the fan of a heater

THE GENERAL DATA

The heater electric motor at the removed lobby of the panel


Details of the back block blowing

---

The prevention

At performance of works on a heater translate the ignition key in position LOCK, disconnect the battery from weight and start works not earlier than in 2 minutes

---

Check

PERFORMANCE ORDER

1. On cars "Toyota 4 Runner/Hilux/Surf" the block blowing a heater is mounted under the forward panel and under a seat of the passenger. In default the fan check up a safety lock and a condition of contacts and wires. 2. Check up on a socket of the electric motor presence of pressure from the battery (include ignition and translate the handle the fan in position ON). 3. If pressure is present, attach a socket and connect a conclusion 2 to weight. If the fan does not join, is possible that the electric motor is faulty. In this case connect conclusions of the electric motor to a food and weight through the wires protected by safety locks. If the electric motor does not join, it is necessary to replace it. 4. If the engine is serviceable, check up the resistor or the switch.

Replacement

PERFORMANCE ORDER

1. Disconnect a socket, turn away 3 screws and get the block blowing from a casing. 2. For access to the back block blowing remove a seat of the passenger.