Audi 100/A6

1990-1997 of release

Repair and car operation



Audi 100/A6
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and a partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
- 11. Suspension brackets, a steering
   11.2. Technical characteristics
   11.3. The general description of adjustment of wheels
   - 11.4. A forward suspension bracket
      11.4.2. A rack of a forward suspension bracket
      11.4.3. Shock-absorbers of a forward suspension bracket
      11.4.4. The bottom lever of a forward suspension bracket
      11.4.5. The stabilizer of cross-section stability of a forward suspension bracket
      11.4.6. A cross-beam of a forward suspension bracket
   + 11.5. A back suspension bracket
   + 11.6. A steering
   + 11.7. Semiaxes
   11.8. Easily and easy
   11.9. Maintenance service of system of a steering
   11.10. Diagnostics of malfunctions of system of a steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice


https://www.youtube.com/channel/UCoah5uA-uF-j35-MalVTfRQ


11.4.2. A rack of a forward suspension bracket Removal

PERFORMANCE ORDER
1. Loosen the a fixing bolt of a nave.
2. Turn off fixing bolts and nuts, fastening the stabilizer of cross-section stability to a body.
3. Remove a wheel and a bolt of fastening of a nave. Remove the wheel gauge if it is necessary (on models with ABS).
4. Turn off fixing bolts of a support and remove a support from a rack.
5. Disconnect the spherical hinge of steering draught from a rack.
6. Turn off a nut and remove a fixing bolt of fastening of the lever of a suspension bracket to a rack.
7. Disconnect the spherical hinge of the lever of a suspension bracket from a rack.
8. Remove a casing, turn off nuts of the top fastening (two nuts are specified by arrows) and remove a rack from the car.

Installation

Installation is spent upside-down removals.

PERFORMANCE ORDER
1. Establish washers and new nuts.
2. Tighten fixing nuts till the demanded moment of an inhaling.

Repair

PERFORMANCE ORDER
1. Remove a rack from the car and establish compressors of springs.
2. Turn off a nut on a rod of the piston of the shock-absorber.
3. Remove a nut and a washer.
4. Remove a fixing plate and a lining (it is specified by an arrow).
5. Remove the plug and the top saddle of a spring.
6. Remove a spring, duster and a rubber emphasis (it is specified by an arrow).
7. By means of the special tool 1 turn off a fixing cap 2 and remove the shock-absorber.
8. Check up the shock-absorber on presence of damages and leak traces. Check up shock-absorber work. Replace the worn out elements of a rack.
9. Establish the bottom end of a spring in deepening in a saddle. Establish the top saddle into place and put on duster a saddle edge.
10. Establish a lining on the top saddle, combine cuts on a lining with heads of bolts (are specified by arrows).
11. Before removal of compressors of a spring check up, that the spring ends concerned an emphasis.

On the main page