Audi 100/A6

1990-1997 of release

Repair and car operation

Audi 100/A6
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and a partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, a steering
- 12. A body
   12.2. Maintenance service and repair
   12.3. A forward bumper
   12.4. A back bumper
   12.5. A cowl
   + 12.6. A rope of opening of a cowl
   12.7. The cowl lock
   12.8. Doors
   12.9. The internal panel of furnish of a door
   12.10. A frame of a window of a door
   12.11. The handle of a door and lock elements
   12.12. Glass and window lifter
   12.13. A luggage carrier cover
   12.14. Elements of the lock of a cover of a luggage carrier
   12.15. A back door
   12.16. Elements of the lock of a back door
   12.17. Elements of the central lock
   + 12.18. Elements electric Glass lifts
   12.19. Rear-view mirrors and the elements connected with them
   12.20. Front and back glass
   12.21. The top hatch
   12.22. External elements of furnish of a body
   12.23. Sitting
   12.24. The mechanism of a tension of forward seat belts
   12.25. Elements of seat belts
   12.26. Panels of furnish of salon
   12.27. The central console
   12.28. The panel of devices
+ 13. An electric equipment
+ 14. A good advice

12.10. A frame of a window of a door
Removal

PERFORMANCE ORDER

1. Remove the internal panel of furnish of a door.

2. Remove fixing clips, fastenings of wires and isolating panel.

3. On a back door disconnect a rope from the lock and lever button.

4. Disconnect a socket of connection from the engine window lifterа and remove wires from a door.

5. Mark position of installation of fixing bolts of a frame. Turn off fixing bolts and remove an adjusting wedge.

6. On a back door unbend consolidation and remove it together with a frame.

Installation

PERFORMANCE ORDER

1. Installation is spent upside-down removals. On termination of installation adjust frame and glass position.

2. At installation check up, that the adjusting wedge (4) has been correctly established between a frame (1) and a door (2), and also that the forward bottom fixing bolt (3) passed through an aperture in a wedge.

3. Check up correctness of a lining of wires and reliability of fastenings.

4. Establish a glass frame so that distance () between an external edge of glass (3) and a decorative strip on a roof (1) was 6,5±1 mm (at the closed door) and consolidation (2) has been a little compressed.

5. Adjust a uvula.

6. Adjust a plane of contact of glass and a rubber insert that the distance instead of exceeded a limit in 0,5–1,0 mm.

7. Adjust the screw in a range of 0,5-1,0 mm.

On the main page