| 1. To grease all rubbing surfaces with greasing Litol-24. |
| 2. To insert into a rubber holder 19 (fig. the Mechanism of management of a gear change (type I see)) loose leaves 18. |
| 3. To press into a rubber holder 19 bottom hemisphere 17 in gathering with a spring 12 and the top hemisphere 7. |
| 4. To insert a rubber holder 19 made narrower by a part into a support 21. |
| 5. Аналогичною подсборку to execute for the mechanism of type II. |
| 6. To establish a basic cover 16. |
| 7. To establish an arm 15 on a support 21 on earlier made labels and to wrap bolts of 14 fastenings. |
| 8. To establish a spring 4 and a washer 3 and to fix its lock ring 2. |
| 9. To screw the handle of 1 lever of a gear change. |
| 10. On the mechanism of type II to establish a rubber holder 7 (cм. Fig. the gear change Lever (type II)) in gathering with the hinge in the case 5 then to establish a metal ring 11 and a rubber support 27. |
| 11. Before transmission installation it is necessary to adjust length of draught 32 (fig. the Mechanism of management of a gear change (type I see)) or draughts 2 (cм. Fig. the Mechanism of management of a gear change (type II)). |
| 12. To remove draught 32 (fig. the Mechanism of management of a gear change (type I see)) from spherical fingers 30 and 33. |
| To adjust length of draught 32 (b = 134 mm) by means of a nut 31. |
| 13. To establish draught 32 on spherical fingers 30 and 33. |