Audi 80/90/Coupe

Since 1986-1991 of release

Repair and car operation

11.4. A steering drive

THE GENERAL DATA

Steering drive

1. Steering transfer Establish precisely on the centre of a shaft of a steering column Establish steering transfer so that there were no warps and a tension If it is necessary, move it It is a little in fastening places 2. An arm of cross-section draught At an inhaling of nuts of fastening of cross-section bent for to an arm, the car should stand on the earth 3. 45 Н.м., always replace 4. 45 Н.м., always replace 5. A washer 6. High pressure pipelines. The moment of an inhaling of fastening: 50 Н.м. Establish шланговый a clip on Inlet hose before removal 7. 20 Н.м., always replace 8. A washer 9. A wheel casing

10. A bolt with a head under a face key Tighten before an inhaling of bolts of fastening of steering transfer to the body panel 11. A spring washer 12. A cover Do not remove from the body panel at removal of steering transfer Establish accurately in a round flute on a casing of the main gear wheel 13. A bolt, always replace 14. A connecting disk remove from a leading gear wheel together with a tube with flanges 15. 25 Н.м., always replace 16. The body panel 17. The return pipeline 18. Sealing rings, always replace 19. A bolt "банджо" The inhaling moment: 40 Н.м. Before untwisting, establish шланговый a clip on the return pipeline

Steering drive (models of release till January, 1989 of release)

1. A cover It is possible to replace, without removing реечный the steering mechanism 2. A lock ring Put on on рейку a steering against the stop Establish a cover on a flute, Passing on a ring circle 3. 20 Н.м. 4. A cover 5. A sealing ring * Always replace 6. The epiploon plug It is established by thicker end upwards 7. A toddler The flute is turned to a cover 8. The case рейки a steering If the case surface is damaged in an installation site of a gear washer, accurately eliminate damage before epiploon installation рейки 9. Рейка a steering Check up рейку on presence of scratches round an epiploon installation site 10. A cap The inhaling moment: 50 Н.м. Tighten by means of two кернеров, established at an angle in 180 ° to each other

11. Basic кольцо* Always replace It is established on a cap 12. A sealing ring *, 44x2.5 mm Always replace It is established on a cap 13. A sealing ring *, 42x2 mm 14. A sealing ring *, always replace 15. A washer 16. The needle bearing 17. A washer 18. Conducting шестерня* 19. An epiploon 20. 20 Н.м. 21. A casing of a leading gear wheel 22. The ball-bearing 23. A sealing ring Always replace 24. A spring It is inserted into a toddler 25. A ring 26. An epiploon рейки the helmsman управления* 27. A lock ring Check up correctness of installation 28. A gear washer Check up correctness of installation 29. A collar Use a collar which is pulled together by means of the screw, the screw should be turned to a body

The system of hydrostrengthening of a steering is filled by a hydraulic liquid, detail G 002 000. All elements marked with an asterisk, are included in the repair complete set and should be replaced during repair.

---

The prevention

Moisten all epiploons in a hydraulic liquid before installation.

Do not try to straighten elements of a steering or to spend on them repair welding works.

Works with a steering drive should be spent on a pure workplace and all elements should contain in absolute cleanliness.

---