Audi 80/90/Coupe

Since 1986-1991 of release

Repair and car operation

7.1.7. The ignition distributor (4-cylinder models)

THE GENERAL DATA

---

The prevention

On a rotor there should be label R1 (for the cars equipped with the generator of the Hall).

---

Installation

PERFORMANCE ORDER

1) And – at the established engine establish a flywheel in the top dead point – the cylinder 1 2) In – at the removed engine – establish a label on виброгасителе (pulley) opposite to a label on a belt cover 3) level a label on an asterisk of a cam-shaft with a cover of a head of cylinders (it is specified by an arrow) 4) level a cut of a ledge of a drive with a carving aperture The prevention The head of a tightening bolt of the distributor is closed by a seal which is necessary for removing if the distributor for any reason acts in film. 5) establish the distributor so that the rotor has been directed on a label for the cylinder 1 on a distributor casing 6) clear a distributor cover before installation, check up it about cracks and soot traces as result искрения, if necessary replace 7) adjust a corner of an advancing of ignition 8) tighten tightening a distributor bolt (25 Н.м.) 9) establish a new seal on a long bolt of the distributor The prevention At replacement of the block of management check up installation of a corner of an advancing of ignition, if necessary adjust.