BMW 3 series E30

Since 1983-1994 of release

Repair and car operation

BMW E30
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmissions
+ 9. Coupling
- 10. Brake system
   10.2. Specifications
   10.3. Antiblocking system (ABS)
   10.4. Колодки disk brakes
   10.5. A support of a disk brake
   10.6. A brake disk
   10.7. Колодки drum-type brakes
   10.8. The main cylinder of brakes
   10.9. The vacuum amplifier of brakes
   10.10. A cable () a manual brake
   10.11. Adjustment of a manual brake
   10.12. The mechanism of a manual brake
   10.13. A brake pedal
   10.14. The switch of a signal of braking
   10.15. Hoses and lines of a hydrodrive of brakes
   10.16. Removal of air from a hydrodrive of brakes
+ 11. A running gear
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice

10.3. Antiblocking system (ABS)

THE GENERAL DATA

Antiblocking system of considered cars

1. The block of management of hydraulics
2. A control lamp
3. The main cylinder
4. The electronic block of management
5. The wheel cylinder
6. The gauge of speed of rotation of a wheel

Arrangement of knots and units of antiblocking system on the car

1. A control lamp
2. The block of management of hydraulics
3. A hydrodrive highway
4. The wheel cylinder
5. A gauge cogwheel
6. The main cylinder
7. The gauge of speed of rotation of a wheel
8. The management block

The ABS-system is intended for increase of controllability and stability of the car at sharp braking at the expense of the pressure control in a line of a hydrodrive of each wheel. At operation of devices of system during sharp braking of a wheel растормаживаются. ABS consists of gauges of speed of rotation of wheels, the electronic block of management and the block of management of hydraulics. Till 1985 on cars 3 gauges of speed – on forward wheels and 1 gauge on a back axis were established. Since 1985 4 gauges – on one on a wheel are established. Signals from gauges are compared in the block of management to a preset value on the basis of what the blocked wheel is defined. The management block develops a signal on the block of management of hydraulics therefore pressure in a wheel contour falls, causing its unblocking.

In malfunction in system specifies fire of a control lamp "ABS" on a guard of devices. Sometimes malfunction is established by external survey of knots of system. Attentively examine conducting and connections on each wheel. If conducting of the gauge of speed the gauge replace (the gauge is damaged is executed at the same time with conducting).
The prevention
It is forbidden to repair system conducting as its electric resistance can be broken that will lead to failures in system work. At any damage of a wire are subject to replacement.

Diagnostics and repair
If the lamp "ABS" on the instrument panel lights up, execute the following:

1. Check up level of a brake liquid in a tank

2. Check up fastenings of sockets of conducting to the electronic block

3. Check up safety locks

4. Check up reliability and absence damage on all connections of conducting

If as a result malfunction is not eliminated, address in car-care centre.

On the main page