BMW 3 series E30

Since 1983-1994 of release

Repair and car operation



BMW E30
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. The engine
   - 3.1.2. Specifications
      3.1.3. Kinds of the repair work which is carried out without dismantle of the engine
      3.1.4. An order of installation of the piston of 1st cylinder in ВМТ a compression step
      3.1.5. A cover of a head of cylinders
      3.1.6. A soaking up collector
      3.1.7. A final collector
      3.1.8. Covers of a chain of a drive of a cam-shaft (engine M10)
      3.1.9. A chain and asterisks (engine M10)
      3.1.10. Covers of a gear belt (engines M20 and М40)
      3.1.11. A gear belt and cam-shaft asterisks (engines M20 and М40)
      3.1.12. Forward epiploons
      3.1.13. A head of cylinders
      3.1.14. The pallet
      3.1.15. The oil pump
      3.1.16. A flywheel (a leading disk)
      3.1.17. A back epiploon коленвала
      3.1.18. Engine mount details
   + 3.2. Dismantle and engine major repairs
   + 3.3. An engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
+ 11. A running gear
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice

3.1.14. The pallet

Removal and installation

PERFORMANCE ORDER
1. Merge oil, lift the car and remove the bottom guards of the engine.
2. Disconnect from the pallet hoses and wires.
3. Turn away bolts viewing лючка.
4. Uncover for access to pallet bolts.
5. On engines M40 turn away bolts and remove the bottom section of the pallet, remove a lining.
6. Turn away a bolt and get a branch pipe маслоуказателя. Check up a condition of a lining of a branch pipe.
7. On engines M40 turn away a nut of lateral support and raise the engine on тали.
8. Turn away bolts of fastening of the pallet.
9. Displace the pallet easy blows and remove, clear the consolidation rests, wash out the pallet. Check up deformation of a condensed plane.
10. At pallet installation put hermetic RTV on places about joints of forward covers with the pallet and the block of cylinders. Replace a lining. Tighten bolts in a cross order, since bolts about the pallet middle.


On the main page