Citroen Xantia
+ Introduction
+ The operation manual
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
+ The power supply system and release
- Engine electric equipment
+ Start and charge systems
+ Ignition system - petrol models
+ Preheat system - diesel models
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ Electric equipment schemes
|
Engine electric equipment
Specifications
Start and charge systems
The general parametres
|
System type |
12-in, with grounding on a negative pole |
The battery
|
Type |
Fulmen, Delco or Steco |
|
Target pressure depending on charge level |
IN |
|
Low level of a charge |
12.5 |
|
Normal level of a charge |
12.6 |
|
Good level of a charge |
12.7 |
The generator
|
Type |
Valeo or Mitsubishi (Melco) (depending on model) |
|
The maximum current, And |
75 or 92 |
|
Adjustable pressure |
IN |
|
The hot engine |
13.8 ÷ 14.5 |
|
The cold engine |
14.2 ÷ 14.8 |
|
The minimum admissible length of brushes, mm |
10 |
Starter
|
Firm-manufacturer |
Valeo or Bosch (depending on model) |
|
Type |
|
Except models with engine RFY (16 valves) |
Bosch 0001 107 019 or Valeo D6RА 66 |
|
Models with engine RFY (16 valves) |
Valeo D6RА 51 |
Ignition system - petrol models
The general parametres
|
System type |
Static (without the distributor), under control ECU of a control system of the engine |
|
Ignition order |
1-3-4-2 |
|
Installation of a corner of an advancing of ignition |
It is supervised ECU (the text see) |
|
Resistance of windings of the coil of ignition (system Magneti-Marelli 8Р) |
Ohm |
|
Primary windings |
0.8 |
|
Secondary windings |
|
• Coil Bosch |
14 000 |
|
• Coil Sagem |
7 100 |
|
• Coil Valeo |
8 600 |
Preheat system - diesel models
Efforts of a tightening of carving connections, Nanometer
|
On the main page
|