Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
- 3. Maintenance service
+ 3.1. Maintenance service of cars with petrol engines
- 3.2. Maintenance service of cars with diesel engines
3.2.1. Operational materials and liquids
3.2.2. Refuelling capacities
- 3.2.3. Periodicity of service
+ 3.2.3.1. Each 400 km
- 3.2.3.2. Each 7 500 km
3.2.3.2.1. Replacement of oil and the oil filter (diesel engines 16D and 16DA)
3.2.3.2.2. Removal of water from a sediment bowl of the fuel filter (diesel engines 16D and 16DA)
+ 3.2.3.3. Each 15 000 km or 12 months
+ 4. The engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes
|
The car should be on an equal platform, the engine should be heated-up.
Oil plums
| PERFORMANCE ORDER |
|
1. Turn away a stopper маслозаливной mouths. Substitute the pallet, clear and turn away a drain stopper, merge oil. |
| 2. Oil should merge not less than 15 minutes Check up a stopper sealant, if necessary replace it. |
| 3. Clear and tighten a drain stopper the demanded moment. Before refuelling by oil execute the following. |
|
Replacement of the oil filter
| PERFORMANCE ORDER |
| 1. Establish the container under the oil filter. By means of a special key release the oil filter (it is possible to drill apertures and to unscrew the filter the inserted screw-driver) then unscrew his hands. Immediately incline the filter and merge oil in the container. |
| 2. Carefully wipe pure rags a place прилегания the filter on the engine. |
|
3. Slightly oil for the engine a sealing ring of the new filter and wrap the filter into place. Tighten the filter by hand, having turned on 2/3 turns after contact of a ring of the filter with a condensed surface. |
|
Refuelling by oil
| PERFORMANCE ORDER |
| 1. At first fill in oil to mark MIN on probeе. |
| 2. Start the engine. The control lamp of pressure of oil should go out after some seconds in process of filling of channels with oil. It is forbidden to increase engine turns during this period. |
| 3. On the working engine check up tightness of a stopper of the oil pallet and a sealing ring of the oil filter, having tracked these places within several minutes, if necessary tighten. Stop the engine and again check up presence подтеканий. |
| 4. Wait some minutes that oil has flown down in the pallet, and again check up oil level. After filling of all channels and the filter oil level can go down. If necessary add oil to a mark "MOVE". Oil volume in the filter about 0,5 l. |
|
|
On the main page
|