Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
- 7. Start and gymnastics system
7.1. A technical characteristics
7.2. A finding of malfunctions in electric chains
- 7.3. The accumulator
7.3.1. Rules of care of the accumulator
7.3.2. Accumulator check
7.3.3. Accumulator gymnastics
7.3.4. Removal and accumulator installation
7.3.5. Check of system of gymnastics
+ 7.4. The generator
+ 7.5. A starter
7.6. Replacement of the lock of ignition
7.7. Removal and installation of the gauge of pressure of oil
7.8. Removal and installation of the gauge of level of oil on models with 16th valves
+ 7.9. The electric equipment of diesel engines 16D, 16DA, 17D and 17DR
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes
|
The degree indicator заряженности and level of electrolit of unattended accumulator DELCO
Decoding of the symbols put on a label of the accumulator
1 – at accumulator service it is necessary to observe rules on
To the safety precautions, stated in the operation manual,
2 – in the accumulator is available
Corroding acid also it is necessary to be careful, that
Acid has not spilt from the accumulator,
3 – do not use open fire
About the accumulator,
|
4 – at work with the accumulator use goggles,
5 – hold the accumulator in a place inaccessible to children,
6 – at recycling the accumulator hand over only in points intended for it,
7 – do not throw out the accumulator together with household dust,
8 – the gases allocated at gymnastics of the accumulator, are explosive |
In the accumulator it is necessary to make check of density of electrolit each 3 months to define loading ability of the accumulator.
Check is made плотномером. At definition of density of electrolit it is necessary to consider accumulator temperature. At electrolit temperature more low 15 ° With on everyone 10 ° From less this temperature from the measured density subtract value 0,007. For everyone 10 ° With from above 15 ° With add 0,007.
The electrolit density in the accumulator should be in following limits:
Temperature
|
Above 25 ° With
|
More low 25 ° With
|
Full gymnastics |
1,210 – 1,230
|
1,270 – 1,290
|
Gymnastics on 70 % |
1,170 – 1,190
|
1,230 – 1,250
|
The discharged |
1,050 – 1,070
|
1,110 – 1,130
|
Electrolit density measure in everyone bank. The difference in density 0,04 or more between two any banks specifies in loss of electrolit or сульфатацию plates.
If the electrolit density between two any banks differs more than on 0,04, the accumulator is subject to replacement. If below demanded, but identical in all banks, the accumulator it is necessary to charge density of electrolit.
In case of use of the unattended accumulator the accumulator condition can be checked up only the voltmeter. In accumulators with the built in indicator of degree заряженности the accumulator condition is defined on colour of the indicator. Green colour of the indicator corresponds to full gymnastics of the accumulator. Black colour of the indicator specifies in necessity of gymnastics of the accumulator. Light or bright yellow colour of the indicator testifies to low level of electrolit in the accumulator (fig. the degree Indicator заряженности and level of electrolit of unattended accumulator DELCO see).
On the accumulator there is a label with warning symbols (fig. Decoding of the symbols put on a label of the accumulator) see.
|
On the main page
|