Audi 100/A6

1990-1997 of release

Repair and car operation


Audi 100/A6
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and a partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
- 11. Suspension brackets, a steering
   11.2. Technical characteristics
   11.3. The general description of adjustment of wheels
   + 11.4. A forward suspension bracket
   - 11.5. A back suspension bracket
      11.5.2. Bearings of a nave of a back wheel
      11.5.3. A pin of a back wheel
      11.5.4. A rack of a back suspension bracket
      11.5.5. Cross-section draught of a back suspension bracket
      11.5.6. The stabilizer of cross-section stability of a back suspension bracket
      11.5.7. A cross-beam of a back suspension bracket
      11.5.8. System of adjustment of height of a back suspension bracket
      11.5.9. Elements of system of adjustment of height of a back suspension bracket
   + 11.6. A steering
   + 11.7. Semiaxes
   11.8. Easily and easy
   11.9. Maintenance service of system of a steering
   11.10. Diagnostics of malfunctions of system of a steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice

11.5.9. Elements of system of adjustment of height of a back suspension bracket
THE GENERAL DATA

THE HYDRAULIC PUMP

Look subsection 11.6.7.

THE ADJUSTING VALVE

Removal
PERFORMANCE ORDER
1. Put on a tube piece the prorolling valve (it is specified by an arrow) and let out pressure from system, having opened the prorolling valve on the left accumulator.
2. Disconnect draught from the valve lever.
3. Turn off nuts of connections and disconnect hydraulic tubes from the valve.
4. Turn off fixing bolts and remove the valve.

Installation

Installation is spent upside-down removals.

Adjustment

PERFORMANCE ORDER
1. Establish wooden blocks in height of 342 mm under the bottom of the car and load a car luggage carrier so that the car bottom concerned blocks.
2. Loosen the a nut of fastening of connecting draught of the valve to a back axis. Combine an aperture in the lever of the valve with an aperture in the case of the valve and block the lever in this position, having inserted into apertures a drill or a bolt.
3. Tighten a fixing nut of connecting draught till the demanded moment of an inhaling.

THE ACCUMULATOR

Removal

PERFORMANCE ORDER
1. Let out pressure from adjustment system.
2. Turn off nuts of connections and disconnect hydraulic tubes.
3. Turn off fixing bolts and remove the accumulator.

Installation

Installation is spent upside-down removals.

SUSPENSION BRACKET RACKS

Look subsection 11.5.4.


On the main page