Audi 100/A6

1990-1997 of release

Repair and car operation

1.29. System of maintenance of constant speed

THE GENERAL DATA

By means of this system – within the possibilities defined by capacity of the engine, – it is possible to support any set speed, beginning approximately about 40 km/h. Thanks to it it is not required to hold a foot on an accelerator pedal that is especially convenient at distant trips.

---

The prevention

The system of maintenance of constant speed cannot use at high intensity of movement and an adverse condition проезжей parts (for example, ice, danger of hydroplaning, gravel emission).

---

At speed over 40 km/h and the included system be not switched to neutral transfer without выжима coupling pedals! Otherwise probably sharp increase in turns of the engine that in certain circumstances is fraught with its breakage!

For using system serve a cursor And and the button In on the lever switch of turn and a passing light.

Inclusion

The system joins transfer of a cursor And in position EIN.

Programming of speed

At achievement of desirable speed to press and release the button In (FIА). The set speed is observed.

Speed can be increased over the programmed value pressing of a pedal of an accelerator. After отпускания the system will adjust pedals speed with return to earlier programmed size. It does not concern cases with excess of the programmed speed more than on 10 km/h over 5 minutes. In this case anew program speed.

Change of speed

Reduction of speed

It is possible to reduce the established speed pressing of the button of V.Pri each short-term pressing of the button speed decreases on 1,5 km/h. At button keeping in the pressed position speed decreases automatically. At release buttons speed is programmed at present.

At release buttons of the car, moving with a speed less than 40 km/h, occur dump of memory of a memory. In this case, after achievement of speed over 40 km/h to program anew speed the button of Century

Increase in speed

The established speed can be increased reduction of a cursor And in position AUFN without pressing an accelerator pedal.

By each short-term pressing of the button speed increases by 1,5 km/h. At button keeping in the pressed position speed increases automatically. At release speed is programmed at present.

Time switching-off of system

Time switching-off of system occurs by pressing of a pedal of a brake or coupling or while translating a cursor And in position AUS (without fixing). The speed programmed to the given moment remains in memory.

For reproduction (AUFN) before the programmed speed translate a cursor And in extreme left position, having released a brake or coupling pedal.

If at time switching-off speed not to program, new speed is established by the switch And in a following order:

On cars with the petrol engine quickly to result in extreme left position the switch And, then again to shift it to the left and to keep before achievement of the necessary speed.

On cars with the diesel engine it is enough to wring out the switch And to the left against the stop and to keep it before achievement of the necessary speed. At release the switch there is a storing of speed.

---

The prevention

Reproduce the programmed speed only in the event that it is not too high for actual traffic conditions.

---

System blackout

The system blackout is carried out by displacement of the switch And against the stop to the right (fixed position AUS) or – at the motionless car – ignition deenergizing.