Audi 100/A6

1990-1997 of release

Repair and car operation



Audi 100/A6
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. Engines
   + 3.1.1.2. Technical characteristics
   - 3.1.2. 5-cylinder engines
      3.1.2.2. Technical characteristics
      3.1.2.3. Sinhronizatsionnye labels timing
      3.1.2.4. Compression check
      3.1.2.5. A gazoraspredelitelnyj belt
      3.1.2.6. Натяжитель газораспределительного a belt, an asterisk
      3.1.2.7. Additional приводной a belt
      3.1.2.8. A camshaft cover
      3.1.2.9. A camshaft epiploon
      3.1.2.10. Epiploons of a cranked shaft
      3.1.2.11. A head of cylinders
      3.1.2.12. Hydraulic pushers
      3.1.2.13. A flywheel
      3.1.2.14. Engine fastenings
      3.1.2.15. The oil pallet
      3.1.2.16. The oil pump and маслозаборный a branch pipe
   + 3.1.3. 6-cylinder engines
+ 3.2. Diesel engines
+ 3.3. Removal and a partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, a steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice


https://www.youtube.com/channel/UCoah5uA-uF-j35-MalVTfRQ


3.1.2.15. The oil pallet
THE GENERAL DATA

The oil pallet

1. Oil probe
2. A sealing ring
3. The gauge of pressure of oil 0,3 bar
4. The gauge of pressure of oil 1,8 bar
5. A maslozabornyj branch pipe
6. A dividing partition
7. The pallet
8. A bolt
9. Заглушка a drain aperture
10. A bolt
11. A flywheel cover
12. A washer
13. A rubber cover
14. A lock spring
15. A bolt
16. An emphasis
17. A lining
18. A bolt
19. A pallet lining
20. An adapter
21. The valve
22. The oil filter
23. A cover of a jellied mouth

Removal

PERFORMANCE ORDER
1. Lift and fix a forward part of the car.
2. Get oil probe and remove the bottom guard of the engine.
3. Merge oil.
4. Remove a forward cover of a transmission.
5. Turn a cranked shaft so that to get access to back bolts of the pallet (arrow).
6. Fix the engine on the lift.
7. Braid the bottom nuts of a support of the engine.
8. Establish a jack under a cross-beam of a forward suspension bracket, unscrew bolts and slightly lower a cross-beam.
9. Unscrew pallet bolts.
10. Remove the pallet.

Installation

PERFORMANCE ORDER
1. Clean surfaces of the pallet and the block of cylinders and establish a new lining.
2. Installation is spent upside-down removals.

On the main page