Audi 100/A6

1990-1997 of release

Repair and car operation


Audi 100/A6
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and a partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Systems of start, ignition
- 9. Transmission
   + 9.1.2. Technical characteristics
   - 9.2. A Mehnichesky transmission
      + 9.2.2. Technical characteristics
      9.2.3. The gear change mechanism
      9.2.4. Removal and installation manual transmission
      9.2.5. Partition manual transmission
      9.2.6. The multipurpose switch and the switch of lanterns of a backing
      9.2.7. The speedometer gauge
      9.2.8. Epiploons
      9.2.9. Evident repair of a transmission 012
   + 9.3. An automatic transmission
+ 10. Brake system
+ 11. Suspension brackets, a steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice

9.2.4. Removal and installation manual transmission Removal
PERFORMANCE ORDER
1. Lift and fix a forward part of the car.
2. Remove the bottom panels of the engine.
3. Disconnect a wire of the minus plug of the accumulator.
4. Disconnect wires from the switch of fires of lanterns of a backing, a speedometer and the multipurpose switch.
5. In 5 cylinder engines unscrew bolts, fastening a jet bar.
6. Unscrew bolts, fastening the top part of a transmission to the engine.
7. Fix the engine on the lift.
8. Remove a cross-beam from under a back part of a transmission.
9. Remove forward section of an exhaust pipe.
10. Remove a starter
11. Disconnect the lever of a gear change from a switching rod.
12. Disconnect shaft from leading flanges.
13. Remove the working cylinder of coupling, but do not disconnect a hose.
14. Establish a jack under a transmission.
15. Unscrew bolts.
16. Unscrew bolts, fastening the bottom part of a transmission to the engine.
17. Disconnect a transmission from the engine and lower it.
18. If necessary remove back support of a transmission. The arrow specifies an adjusting pin of a back support of a transmission.

Installation

Installation is spent upside-down removals.


On the main page