Audi 100

1982-1990 of release

Repair and car operation




Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. An exhaust system
+ 6. The power supply system
+ 7. Transmission
+ 8. A running gear
+ 9. A steering
+ 10. Brake system
+ 11. A body
- 12. An electric equipment
   - 12.1. Electric equipment system
      12.1.1. A technical characteristics
      12.1.2. Safety locks, the relay and management blocks
      + 12.1.3. The generator
      + 12.1.4. A starter
      - 12.1.5. Illumination and the light alarm system
         12.1.5.1. Replacement of a lamp of a headlight
         12.1.5.2. Replacement of a lamp of dimensional light
         12.1.5.3. Removal and headlight installation
         12.1.5.4. Adjustment of light of headlights
         12.1.5.5. Replacement of a lamp of the index of turn
         12.1.5.6. Removal and installation of the index of turn
         12.1.5.7. Replacement of a lamp of an antifog headlight
         12.1.5.8. Adjustment of light of antifog headlights
         12.1.5.9. Replacement of lamps of a back lantern by a wing
         12.1.5.10. Replacement of lamps of a back lantern by a luggage carrier cover
         12.1.5.11. Replacement of a lamp of a lantern of illumination of licence plate
         12.1.5.12. Replacement of a lamp of a lantern of illumination of a luggage carrier
         12.1.5.13. Replacement of a lamp of a plafond of illumination of salon
         12.1.5.14. Replacement of a lamp of a plafond of a directional light
         12.1.5.15. Removal and installation of a combination of devices
         12.1.5.16. Voltage stabilizer check
         12.1.5.17. Removal and installation of the relay-breaker of indexes of turn
         12.1.5.18. Check of the switch of light of a backing
         12.1.5.19. Check of the gauge of the index of temperature of a cooling liquid
         12.1.5.20. Check of the index of level of fuel
         12.1.5.21. Adjustment of the index of level of fuel
         12.1.5.22. Removal and installation of a screen wiper of a windscreen
   + 12.2. Ignition system
   + 12.3. Electric schemes

12.1.5.22. Removal and installation of a screen wiper of a windscreen
THE GENERAL DATA

Windscreen screen wiper

1 – a brush;
2 – the brush lever;
3 – a cap;
4 – a nut;
5 – a spring washer;
6 – an arm;
7 – draught of a drive;
8 – the lever;
9 – a bolt;
10 – the screen wiper electric motor;
11 – a jet of a washer of a windscreen;
12 – the valve;
13 – an arm of hoses of a washer;
14 – the electric motor of a washer of a windscreen;
15 – a tank of a washer of a windscreen;
16 – the water level gauge in a tank;
17 – a bolt

PERFORMANCE ORDER
1. To open a cowl.
2. To disconnect a wire from "the minus" plug of the storage battery.
3. To pick up a screw-driver and to remove protective caps from screen wiper levers.
4. To turn on not to the end (not to spoil a carving on platens) nuts of fastening of levers of a screen wiper. By means of flat-nose pliers to pull off both levers with шлицов platens of the mechanism of a screen wiper and, having turned on definitively nuts, to remove levers.
5. To remove a protective casing.
6. To disconnect wires from the screen wiper electric motor.
7. To turn on on one bolt of fastening from each party of levers of the mechanism of a screen wiper.
8. To disconnect a bolt of fastening of an arm and to remove the screen wiper mechanism in gathering.
9. To establish a screen wiper upside-down. Thus a bolt of fastening of an arm to tighten the moment 4 Н·м (0,4 кгс·м), and bolts of fastening of support – the moment 7 Н·м (0,7 кгс·м).
10. Screen wiper levers to establish so that brushes at rest were in parallel a tangent to a line of a contour of a windscreen.


On the main page