Audi 100

1982-1990 of release

Repair and car operation

8.2.5. Adjustment of bearings of a nave of a wheel

PERFORMANCE ORDER

1. To establish an emphasis under forward wheels. 2. To raise and establish on a support a back part of the car. 3. To bring down a protective cap of a nut of a nave a hammer with a rubber tip. 4. To take out шплинт and to remove a clamp of a nut of a nave. 5. To tighten a nave nut against the stop, turning thus a wheel for self-installation of bearings of a nave. Then slightly to release a nut until when the washer can be shifted by means of a screw-driver effort of a hand. Is thus inadmissible to use a screw-driver as the lever, leaning to it against a nave fillet. 6. To establish a clamp and шплинт. For aperture coincidence in a pin under шплинт and cuts in a clamp the nave nut is necessary for tightening only. 7. To add консистентную greasing in a protective cap of a nut of a nave to two thirds of its volume and запрессовать it into place by means of approaching оправки. Crushed and треснутые protective caps are subject to obligatory replacement (in avoidance of hit of a dirt and a moisture in a nave).