+ 1.1. Controls and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. An exhaust system
+ 6. The power supply system
+ 7. Transmission
+ 8. A running gear
- 9. A steering
9.1. A technical characteristics
9.2. A steering wheel
+ 9.3. A steering column
9.4. The steering mechanism
9.5. Adjustment of the mechanism of a steering
9.6. Steering draught
9.7. The pump of the hydraulic booster of a steering
9.8. Check of pressure of forcing of the pump of the hydraulic booster of a steering
9.9. Prorolling of system of the hydraulic booster of a steering
9.10. A privodnoj belt of the pump of the hydraulic booster
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment
1 – a decorative overlay;
2 – a steering wheel;
3 – a nut;
4 – a nut;
5 – колодка with wires;
6 – a washer;
7 – a spring;
8 – the bearing;
9 – подрулевые switches;
10 – a pipe;
11 – an arm of a steering column;
|12 – the top shaft of a steering;
13 – the plug;
14 – the plastic plug;
15 – the bottom shaft of a column of a steering;
16 – a collar;
17, 18, 21 – bolts;
19 – an arm;
20 – the switch of ignition with the antijoy ride device
On the cars completed with a pillow of safety, the steering wheel can be removed only at servicing deports.
| PERFORMANCE ORDER
|1. To disconnect a wire from "the minus" plug of the storage battery.
|2. To establish forward wheels in position of movement of the car on a straight line.
|3. To remove a decorative overlay and to disconnect from it колодку with wires of the switch of a sound signal.
| 4. To mark a relative positioning of a steering wheel and a shaft of a steering column.
|5. To turn away a nut of fastening of a steering wheel on so much that its end face was заподлицо with an end face of a shaft of a steering column.
|6. Shaking for spokes, with force to pull on itself a steering wheel so that it has descended with шлицев a steering shaft. To turn away definitively nut and to remove a washer and a steering wheel.
| PERFORMANCE ORDER
|1. Before installation to check up, that forward wheels were in position of movement of the car on a straight line and the lever of the switch of indexes of turn was in neutral position. Thus рычажок switching-off of indexes of turn should be directed to a left-hand side.
|2. To establish a steering wheel on a shaft according to earlier made label.
|3. To establish a washer and to wrap a nut of fastening by the moment 40 Н·м (4,0 кгс·м).
| 4. To insert coal contact to a wire into a steering wheel nave.
|5. To connect колодку with a wire to a decorative overlay and to establish an overlay on a steering wheel.
||6. To check up distance from a casing of a steering wheel to a casing подрулевых switches which should be equal 3 mm. If this distance differs from specified, to weaken fastening подрулевых switches through an aperture located from below in a casing подрулевых of switches. To expose the demanded distance and to fix подрулевые switches.
|7. To make a trial trip. At car movement on direct spokes of a steering wheel should be located horizontally. Otherwise to remove a steering wheel and to establish it anew.
On the main page