Audi 100

1982-1990 of release

Repair and car operation




Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. An exhaust system
+ 6. The power supply system
+ 7. Transmission
+ 8. A running gear
- 9. A steering
   9.1. A technical characteristics
   9.2. A steering wheel
   + 9.3. A steering column
   9.4. The steering mechanism
   9.5. Adjustment of the mechanism of a steering
   9.6. Steering draught
   9.7. The pump of the hydraulic booster of a steering
   9.8. Check of pressure of forcing of the pump of the hydraulic booster of a steering
   9.9. Prorolling of system of the hydraulic booster of a steering
   9.10. A privodnoj belt of the pump of the hydraulic booster
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment

9.7. The pump of the hydraulic booster of a steering
THE GENERAL DATA

The pump of the hydraulic booster of a steering (the 5-cylinder engine)

1 – a bolt;
2 – a forward arm on the pump;
3 – an arm;
4 – a back arm on the pump;
5 – a bringing hose;
6 – a taking away hose;
7 – a hose of giving of a liquid to a receiver;
8, 10 – nuts;

9 – an adjusting bolt;
11 – an adjusting lath;
12 – the pump;
13 – a bolt of fastening of an adjusting lath;
14 – a bolt of an adjusting lath;
15 – a belt

The pump of the hydraulic booster of a steering (the 4-cylinder engine)

1 – an adjusting washer;
2 – an external half of pulley;
3 – a belt;
4 – an internal half of pulley;
5 – a forward arm;
6 – the pump;
7 – a taking away hose;
8 – a bringing hose;
9 – a back arm;
10 – a lath;
11 – a hose of giving of a liquid to a receiver

Removal

PERFORMANCE ORDER
1. To remove a belt of a drive of the pump.
2. To mark hoses, for example, a sticky tape. To turn off bringing bolts of fastening and to disconnect hoses from the pump, having removed sealing rings (them necessarily replace).
3. To turn out an adjusting bolt and a bolt of an adjusting lath.
4. To turn off a nut, to take out a bolt and to remove the pump from an arm.

Installation

PERFORMANCE ORDER
1. To establish the pump on an arm, to insert a bolt and to wrap a fastening nut, without tightening it.
2. To connect hoses tips to the pump according to earlier made marks and to wrap bringing bolts, preliminary having put new sealing rings. To tighten bringing bolts the corresponding moment. To watch, that hoses were not overwound.
3. To establish and pull приводной a belt (subsection 9.10 see).
4. To pump over hydraulic system of a steering (subsection 9.9 see).


On the main page