Audi 80/90/Coupe

Since 1986-1991 of release

Repair and car operation



Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburettors
3. Greasing system
+ 4. Cooling system
- 5. Fuel system
   - 5.2. Systems of injection of fuel
      5.2.1.2. Specifications (4-cylinder models)
      5.2.1.3. Components of system of injection for 5-cylinder models
      5.2.1.4. Specifications (5-cylinder models)
      5.2.1.5. A starting position of a plate of the gauge of an air stream
      5.2.1.6. A free wheeling of a plate of the gauge of an air stream
      5.2.1.7. The lever of a plate of the gauge of an air stream
      5.2.1.8. Operating плунжер
      5.2.1.9. The throttle valve
      5.2.1.10. A rope of management throttle заслонкой
   5.2.2. Fuel injectors (20-klapannye models)
   + 5.2.3. An electronic control system of engine MPI
+ 6. An exhaust system
+ 7. Ignition system
+ 8. Transmission
+ 9. Suspension brackets, wheels
+ 10. Brake system
+ 11. A steering
+ 12. A body, salon
+ 13. A central air
+ 14. An electric equipment

5.2.1.8. Operating плунжер Removal / installation

PERFORMANCE ORDER
1) write down value "and" before removal of the lock screw
2) remove the lock screw and disconnect operating плунжер
3) clear operating плунжер gasoline before installation
4) check up a sealing ring of the lock screw about damages, if necessary replace (smaller diameter of a sealing ring is directed to the managing director плунжеру)
5) wrap the lock screw back to value "and"
6) check up and adjust a starting position and a backlash of a plate of the gauge

The prevention

Mechanical clearing of the managing director плунжера is inadmissible. If after clearing by solvent the managing director плунжер is scratched or заедает, it is necessary to replace all distributor of fuel.



On the main page