Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburettors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Ignition system
- 8. Transmission
8.1.2. A plug - the main cylinder of coupling
8.1.3. Press a coupling disk
8.1.4. Malfunctions of coupling
- 8.2. A mechanical transmission 012
8.2.2. The lever mechanism of the lever of a gear change
8.2.3. Removal and transmission installation
8.2.4. Differential mechanisms
+ 8.3. A mechanical transmission 01А
+ 8.4. An automatic transmission 089
+ 8.5. An automatic transmission 087
8.6. Dismantling and assemblage of automatic transmissions
8.7. The block of valves
+ 8.8. An automatic transmission 097
+ 9. Suspension brackets, wheels
+ 10. Brake system
+ 11. A steering
+ 12. A body, salon
+ 13. A central air
+ 14. An electric equipment
|
The gear change lever in gathering
1. The gear change lever
Can be inserted into a spherical support only in one position
2. A lock ring
Always replace
The roundish party should be turned to a spherical support
Remove before removal of a spherical support
3. 25 Н.
4. A lamellar spring
5. A side scene
6. Draught of a gear change
Colour code: blue = for engines with 5 cylinders
7. A cover
8. A clip
9. 25 Н.м.
10. 20 Н.м.
Always replace
The screw is greased by hermetic
11. The basis of the lever of a gear change
Fastens on a floor by means of hermetic AKD 512 001
12. 10 Н.м.
13. A switching plug
14. 10 Н.м.
|
15. A directing cup
It is necessary to establish restrictions for movement of a spherical support at the left and on the right
Emphasis establish so that at inclusion of transfer of a backing the lever has been inclined to the left
16. A spherical support
Establish a spring and the plug in a spherical support, and then establish the gear change lever so that the spring and the plug were on the correct party in a moving direction
Establish a spherical support before installation стопрного rings
17. The plug
The roundish end is turned to the gear change lever
18. A spring
19. An axis of the lever of a gear change
20. The raspornaja plug
21. A lock ring.
22. A cover
For removal unscrew the screw
23. The screw
24. The handle |
The prevention Do not grease the lever mechanism of the lever of a gear change.
Adjustment
| PERFORMANCE ORDER |
| 1) move the gear change lever to neutral position |
| 2) remove the lever handle, unscrew the screw of fastening of a cover of the lever and remove a cover |
|
3) ослабьте a bolt (it is specified by an arrow)
|
| 4) establish the gear change lever vertically (as far as possible) |
|
Check
| PERFORMANCE ORDER |
|
1) establish the gear change lever so that both uvulas on a spherical support were on identical distance "a" (it is specified by arrows) from a directing cup |
| 2) tighten a bolt and check up, that the lever did not move |
| 3) check up work of the mechanism of a gear change, include all transfers by turns |
| 4) 3-ja/4th transfers should be in the same plane, as neutral |
| 5) check up work of a safety latch of transfer of a backing. If it does not work, turn off screws and turn directing cup a little |
| 6) establish a cover and the handle of the lever of a gear change |
|
|
On the main page
|