|
|
| 1. Before installation of new piston rings sort rings and check up a backlash in joints. For this purpose push a ring the piston bottom. The ring should be in the bottom part of the cylinder, in the position corresponding to the bottom dead point. |
|
2. If the backlash is too small, thin надфилем cautiously file ring end faces, having clamped it in a vice. The backlash increase in a joint to 1,0 mm is supposed. |
| 3. Repeat procedure for all rings of one piston. |
|
4. Establish rings on the piston, having begun with маслосъемного. Establish in a flute a divider / a ring dilator. Be convinced available a pin of a flute (if it is provided) and establish the bottom and top disks. |
|
5. At installation маслосъемных disks to use the adaptation for clothing of rings it is impossible, as their breakage is possible. Insert a disk, press also a finger from one end spend on a ring, having laid that it in a flute. |
| 6. Similarly establish rings on other pistons. |