BMW E30
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmissions
- 9. Coupling
9.2. Specifications
9.3. Coupling check
9.4. The main cylinder of coupling
9.5. A coupling pedal
9.6. The blocking switch of coupling
9.7. The working cylinder of coupling
9.8. Removal of air from a coupling hydrodrive
9.9. Coupling details
9.10. A kardannyj shaft
9.11. Elastic муфта
9.12. An average support
9.13. Kardannye hinges
9.14. The forward aligning plug
9.15. The SHRUS карданного a shaft
9.16. Semiaxes
9.17. SHRUS and covers
9.18. Epiploons of a reducer of a back axis
9.19. A reducer of a back axis
9.20. An epiploon of a leading gear wheel of a reducer
+ 10. Brake system
+ 11. A running gear
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice
|
Coupling
|
1. Press a disk
2. A frictional disk
3. The lever of deenergizing of coupling
4. The vyzhimnoj bearing
|
5. The spherical hinge
6. A spring
7. A bolt |
Coupling
|
1. A flywheel
2. A frictional disk
3. Press a disk and a coupling casing
4. The vyzhimnoj bearing
5. To a nutritious tank
6. The main cylinder of deenergizing of coupling
7. The union for air removal
|
8. The working cylinder of deenergizing of coupling
9. A pusher
10. The lever
11. The lever of a press disk
12. The directing bearing
13. Коленвал
14. A bolt of fastening of a flywheel |
Coupling dry, one-disk, with диафрагменной a press spring and a hydrodrive.
Check
It is recommended to execute following preliminary checks which allow to define a condition of coupling and deterioration of its details.
| PERFORMANCE ORDER |
| 1. Check up liquid level, if necessary restore (if the tank is empty, add a liquid and pump over a hydrodrive). Define the leak reason. |
| 2. For check of proslipping of coupling press a pedal idling the engine and after some seconds include a reverse gear. The gnash will specify in the strengthened deterioration of press or frictional disks. |
|
|
3. Check up completeness of deenergizing of coupling. For this purpose on the working engine press a coupling pedal so that the pedal did not reach a floor on 6 mm. Be some times switched from 1st transfer to the back. The complicated switching specifies in deterioration of details. Check up a course of a rod of the working cylinder at completely pressed pedal. For this purpose insert into a special crack a metal strip and press to a rod. |
| 4. Ask the assistant to press a pedal and to release, – the strip thus will leave a scratch which length is equal to a rod course. The rod course should be equal 20 mm. If the course is small, air hit, подтекание cylinder consolidations, or jamming of a disk of coupling on primary to a check point shaft can be the reason. |
| 5. Check up a condition of the plug of an axis of a pedal, be convinced that the pedal freely moves. |
|
|
On the main page
|