BMW 3 series E30

Since 1983-1994 of release

Repair and car operation


BMW E30
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmissions
- 9. Coupling
   9.2. Specifications
   9.3. Coupling check
   9.4. The main cylinder of coupling
   9.5. A coupling pedal
   9.6. The blocking switch of coupling
   9.7. The working cylinder of coupling
   9.8. Removal of air from a coupling hydrodrive
   9.9. Coupling details
   9.10. A kardannyj shaft
   9.11. Elastic муфта
   9.12. An average support
   9.13. Kardannye hinges
   9.14. The forward aligning plug
   9.15. The SHRUS карданного a shaft
   9.16. Semiaxes
   9.17. SHRUS and covers
   9.18. Epiploons of a reducer of a back axis
   9.19. A reducer of a back axis
   9.20. An epiploon of a leading gear wheel of a reducer
+ 10. Brake system
+ 11. A running gear
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice

9.7. The working cylinder of coupling

Removal and installation

PERFORMANCE ORDER
1. Remove a liquid from a tank of a hydrodrive of coupling.
2. Lift car redock.
3. Disconnect a hose of a hydrodrive of coupling, for this purpose on a part of cars it is required to remove the cylinder.
4. Turn away a nut and remove the cylinder. 1. A hydrodrive hose
2. Nuts
3. The union for air removal
5. Check up deterioration plastic heads of a pusher and the pusher lever. The lever as a rule wears out only in deepening under a pusher. The strengthened deterioration on each side and on the lever out of deepening specifies heads of a pusher in infringement of axial position of a pusher.
6. At leak detection through consolidation of a pusher the cylinder replace. At replacement consider that on models with a usual flywheel the cylinder with internal diameter 20,64 mm, and on models with a dual flywheel – with internal diameter 22,2 mm is established.
7. Installation is carried out upside-down. Grease a pusher head молибденовой with greasing and be convinced that the pusher has come into deepening on the lever. Fill in a liquid and remove air.


On the main page