BMW 3 series E30

Since 1983-1994 of release

Repair and car operation

BMW E30
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmissions
- 9. Coupling
   9.2. Specifications
   9.3. Coupling check
   9.4. The main cylinder of coupling
   9.5. A coupling pedal
   9.6. The blocking switch of coupling
   9.7. The working cylinder of coupling
   9.8. Removal of air from a coupling hydrodrive
   9.9. Coupling details
   9.10. A kardannyj shaft
   9.11. Elastic муфта
   9.12. An average support
   9.13. Kardannye hinges
   9.14. The forward aligning plug
   9.15. The SHRUS карданного a shaft
   9.16. Semiaxes
   9.17. SHRUS and covers
   9.18. Epiploons of a reducer of a back axis
   9.19. A reducer of a back axis
   9.20. An epiploon of a leading gear wheel of a reducer
+ 10. Brake system
+ 11. A running gear
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice

9.8. Removal of air from a coupling hydrodrive

THE GENERAL DATA

System prorolling is required every time after carrying out of dismantling and assemblage of a highway of a hydrodrive of coupling.

PERFORMANCE ORDER

1. Finish liquid level in a tank to a mark the MOVE.

2. Lift car redock.

3. Remove a cap, dress on the union of the cylinder a hose. Lower other end a hose in the capacity filled on 1/3 brake liquid.

4. Ask the assistant to press a coupling pedal some times to the full and удердживать a pedal of the pressed. Turn away the prorolling union on 1/2 turns. Tighten the union after a liquid exit. Ask the assistant to release a pedal.

5. Repeat procedure until the hose with a liquid will not cease to leave air vials. Constantly watch level, – the tank should be filled by a liquid.

6. At the pressed pedal tighten the union, dress a cap and lower the car. Restore liquid level in a tank.

On the main page