Citroen Xantia

1. Remove assemblage of the right power shaft (Removal and installation of power shafts see).
2. Check up freedom of rotation of an external holder of the bearing (mutual люфт between holders should remain uniform). In case of need make bearing replacement (see further).

3. By means of a special universal stripper with long directing accurately remove assemblage of the intermediate bearing with the landing plug from internal section of a shaft. Slightly grease with dense greasing an internal holder of the new bearing and plant it on a shaft pin. Putting blows by a hammer on an internal holder through made of a piece of a pipe of suitable diameter выколотку, plant bearing assemblage on a shaft against the stop it in external section of the SHRUS. Afterwards plant the plug, densely having pressed it to an internal holder of the bearing.

4. Check up freedom of rotation of the bearing, then establish power shaft assemblage on the car (Removal and installation of power shafts see).