Citroen Xantia
- Introduction
Cars Citroyon Xantia - the summary
Acquisition of spare parts and identification numbers of the car
Technology of performance of repair procedures
Tools and the workplace equipment
Operations procedure in extreme situations
Поддомкрачивание and towage
Change of wheels
Start of the engine from an auxiliary source
Identification of leaks
Preparation of the car for checkup
Diagnostics of malfunctions of knots and car systems
Features of the countries PDD of Europe
+ The operation manual
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ Electric equipment schemes
|
Start of the engine from an auxiliary source
|
|
Use of the auxiliary power supply will help to make engine start in an extreme situation, however then it is necessary to find out and eliminate the reason which has led to the category of the battery. |
It is possible to carry the following to number of the most typical reasons:
1. Подсадка the battery has resulted from carrying out of unsuccessful attempts of start of the engine, or owing to оставления included lighting devices.
2. Serviceability of functioning of system of a charge (ослаб or it is torn off приводной a generator belt, is damaged connecting electroconducting, or is faulty actually the generator) is broken.
3. The battery (electrolit level has fallen, or there was an accumulator service life) is faulty actually.
At performance of start of the engine from the external power supply it is necessary to pay attention to observance of some special safety measures:
• Before connecting the auxiliary battery, make sure that ignition is switched off.
• Track, that all consumers of the electric power (lighting and heating devices, screen wipers, etc.) also have been switched off.
• Attentively study warning information on a battery label.
• Make sure that the auxiliary battery on the working parametres corresponds established on your car.
• If as the auxiliary power supply the battery established on other vehicle is used, track, that cars did not adjoin AT ALL with each other.
• Make sure that transmission is included on neutral transfer (in case of АТ - position “Р”).
The scheme of inclusion of auxiliary consumers of the electric power
|
|
Inclusion of auxiliary consumers of the electric power is made for the purpose of prevention of jumps of pressure at the moment of an electroconducting detachment. |
|
|
|
1. Connect the end of a red wire from the special complete set to the positive plug of the sat down battery (the Scheme of inclusion of auxiliary consumers of the electric power see 1 an illustration). |
|
|
2. The second end of a red wire connect to the positive plug of the auxiliary battery (the Scheme of inclusion of auxiliary consumers of the electric power see 2 an illustration). |
|
|
3. One end of a black wire from the complete set connect to the negative plug of the auxiliary battery (the Scheme of inclusion of auxiliary consumers of the electric power see 3 an illustration). |
|
|
4. The second end of a black wire connect to reliably earthed point on the block of the started engine (a bolt or an arm), whenever possible far away from the battery (the Scheme of inclusion of auxiliary consumers of the electric power see 4 an illustration). |
|
|
5. Make sure that connecting wires do not adjoin to moving components in impellent compartments of both cars (крыльчатка the fan, приводные belts, etc.). |
|
6. Execute standard procedure of start of the engine. Leave the engine working on single turns. Include headlights, a heater of back glass and the heater fan, then disconnect wires, operating in an order, the return to an order of their connection (see above). On termination of procedure switch off superfluous consumers of the electric power. |
|
|
On the main page
|