Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation


Тойота 4Раннер
- 1. The maintenance instruction
   1.2. The panel of devices
   1.3. The combined devices
   1.4. A designation of symbols of light indexes
   1.5. Keys
   1.6. Immobilizer system (recognition of a code of start-up of the engine)
   + 1.7. Doors
   1.8. A cover of a fuel tank
   1.9. Adjustment of a forward seat
   1.10. Adjustment of an inclination of a steering wheel
   1.11. Adjustment of position of a rear-view mirror
   1.12. A plafond of internal illumination
   1.13. A plafond of individual illumination
   1.14. A cleaner and a windscreen washer
   1.15. A cleaner and a washer of back glass
   + 1.16. Headlights and turn indexes
   1.17. A heater of back glass
   1.18. The index of a stock of fuel
   1.19. The remote thermometer of cooling means
   1.20. A measuring instrument of pressure of oil
   1.21. The voltmeter
   1.22. A tachometre
   1.23. The counter of the general run and the counter of daily run
   + 1.24. Indexes and warning signals
   1.25. The lock of ignition and the lock of a steering column
   1.26. An automatic box
   1.27. Radio receiver AM-UKV with electronic adjustment
   1.28. The AM-UKV-RADIO TAPE RECORDER with electronic adjustment
   1.29. Adjustment of a direction of a stream of air
   1.30. Controls a heater
   1.31. Hours
   1.32. Cigar Lighter and an ashtray
   1.33. A perchatochnyj box
   1.34. The container for trifles
   + 1.35. Actions at refusal of start-up of the engine
   1.36. Identification numbers of the car
   1.37. Identification number
   1.38. The production certificate
   1.39. A VECI-label
   1.40. Numbers on transmission units
   1.41. A raising of the car a jack
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. A suspension bracket and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes

1.27. Radio receiver AM-UKV with electronic adjustment

Using a radio receiver

PERFORMANCE ORDER
1. Include the receiver, having turned handle "PWR.VOL" clockwise.
2. Adjust loudness further turning handle "PWR.VOL".
3. Be adjusted on the necessary station (see below subitem 1-10 and subitem 1-6).
4. For VHF reception (FM) - radio stations be switched to a mode of reception of VHF (FM), choose a mode of a stereo or monophonic reception.
5. If transfer on VHF-stereo the receiver will automatically be switched to stereo reception is accepted, simultaneously on the display there will be symbol ST.
6. If a signal weak be switched to a monophonic mode, having pressed the corresponding button. On the display there will be symbol MONO.
7. Adjust a timbre and balance (see more low).
8. To switch off the receiver, turn handle "PWR.VOL" against an hour hand.

Adjustment for station

PERFORMANCE ORDER
1. For a choice моно or stereoreception press button L.M/U. On the display there will be symbols L.MW or UKW.
2. Be adjusted on the necessary station by means of one of offered below ways. On the display there will be a value of frequency of adjustment.
Adjustment in a program mode
3. Press the button of a choice of station which has been in advance brought in memory. The receiver will automatically be adjusted on the given station, and on the display button number (see more low) will be displayed.
4. A mode of continuous search. In this mode there is a station search. After reception of station adjustment automatically stops.
5. Press simultaneously on both parties of button TUNE and wait a continuous sound signal.
6. The receiver will start to carry out automatically search of the nearest station with higher or lower frequency of an announcement.
7. After confident reception adjustment stops.
8. By the subsequent pressing of the button search will proceed before confident reception of the following station.
9. If because of too weak signal it is not possible to be adjusted after unitary scanning of all range of frequencies search will proceed, but at a hypersensibility, and on the display there will be symbol DX.
Manual adjustment
10. Press simultaneously on both parties of button TUNE for a while not exceeding 0,5 seconds By each pressing of the button occurs перескок to frequency on which the announcement is possible.

Adjustment programming

PERFORMANCE ORDER
1. Be adjusted on the necessary station (see above).
2. Press the button of a choice of station and wait a sound signal.
3. Thus the station will automatically join by pressing the given button, which number will appear on the display.
4. On each button it is possible to remember one Am-station and one VHF-station.
5. To bring in memory adjustment for new station repeat the procedure described above.
6. Adjustment for the programmed station is erased at food switching-off (a battery detachment, перегорании a safety lock etc.).

ARI-station reception (the road information)

PERFORMANCE ORDER
1. Press button L.M/U. On the display there will be symbol UKW.
2. Press button VF. The receiver will be switched to a mode of reception ARI, on the display there will be symbol VF.
3. Be adjusted on the necessary station broadcasting the ARI-information (fig. above see). After adjustment for ARI-station for the display there will be symbol SK.
4. For ARI-announcement cancellation repeatedly press button VF.

Timbre adjustment

It is provided with handle TONE turn.

Balance adjustment

PERFORMANCE ORDER
Pull on itself handle PWR.VOL and turn.


On the main page