1990-1997 of release
Repair and car operation
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. Engines
+ 184.108.40.206. Technical characteristics
+ 3.1.2. 5-cylinder engines
- 3.1.3. 6-cylinder engines
220.127.116.11. A gear belt
18.104.22.168. A head of cylinders
22.214.171.124. Replacement маслосъемных caps of valves
126.96.36.199. Check of directing valves
188.8.131.52. Fair processing of a landing facet of a saddle / the valve
184.108.40.206. Grinding in of saddles of valves
220.127.116.11. Compression check
18.104.22.168. A poliklinovoj belt
22.214.171.124. Greasing system
126.96.36.199. The oil pump
+ 3.2. Diesel engines
+ 3.3. Removal and a partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, a steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice
At repair of engines with leaky valves there are not enough valves only дообработать or to replace. Besides urgently it is necessary to check up directing valves on deterioration. Check for engines with long service life is especially important. If deterioration too big it is necessary or to replace directing valves (only in a workshop) or to replace a head of cylinders.
Deposit adjournment on directing valves remove by means of development for cleaning.
Insert the new valve. The end face of a core of the valve should not leave from directing.
By the indicator of linear moving measure value of moving of a plate of the valve at it качании.
Deterioration border: directing the inlet valve – 1,0 mm, directing the final valve – 1,3 mm.
At большем value of moving replace directing valves in a workshop.
On the main page