Audi 100/A6

1990-1997 of release

Repair and car operation



Audi 100/A6
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
- 3.2. Diesel engines
   + 3.2.1.2. Technical characteristics
   - 3.2.2. 5-cylinder engines
      3.2.2.2. Technical characteristics
      3.2.2.3. Sinhronizatsionnye labels timing
      3.2.2.4. Compression check
      3.2.2.5. A gazoraspredelitelnyj belt
      3.2.2.6. A privodnoj belt of the fuel pump
      3.2.2.7. Натяжитель газораспределительного a belt and an asterisk
      3.2.2.8. Additional приводной a belt
      3.2.2.9. A camshaft cover
      3.2.2.10. Camshaft epiploons
      3.2.2.11. Epiploons of a cranked shaft
      3.2.2.12. A head of cylinders
      3.2.2.13. Hydraulic pushers
      3.2.2.14. A flywheel
      3.2.2.15. Engine fastenings
      3.2.2.16. The oil pallet
      3.2.2.17. The oil pump and маслозаборный a branch pipe
+ 3.3. Removal and a partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, a steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice



3.2.2.3. Sinhronizatsionnye labels timing
THE GENERAL DATA

Asterisks of a cranked shaft, camshaft and intermediate shaft have a drive from газораспределительного a belt and rotate inphase.

If phase synchronism of rotation of asterisks is broken, valves will concern pistons during rotation of a cranked shaft.

The highest point which reaches piston N1 at the moment of a compression step is accepted to the top dead point.

Shaft blocking by the self-made device


PERFORMANCE ORDER
1. To establish piston N1 in ВМТ, unscrew candles of prestarting heating.
2. Having turned a cranked shaft, combine синхронизационную a label, on a flywheel with a ledge on a casing of a transmission and a label on an asterisk of the fuel pump with a label on the pump case.
3. By means of special tools block a camshaft (fig. shaft Blocking by the self-made device see also).
4. Centre the blocked camshaft by means of measuring probeов. Now, piston N1 is in ВМТ.

On the main page