Audi 100/A6

1990-1997 of release

Repair and car operation


Audi 100/A6
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and a partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
- 8. Systems of start, ignition
   - 8.1.1. Introduction
      8.1.2. Technical characteristics
      - 8.1.3. The accumulator
         8.1.3.2. Removal and installation
      + 8.1.4. The Generator / system of additional charge of the accumulator
      8.1.5. Replacement of the holder of brushes and a regulator of pressure of the generator
      8.1.6. Check of system of start of the engine
      8.1.7. A starter
      8.1.8. An inlet gas pipeline
      8.1.9. A cable of gas/lever throttle заслонки (DB)
      8.1.10. A cable of management of gas (DB)
      8.1.11. A contour of fuel of the diesel engine
      8.1.12. Prestarting heating of diesel fuel
      8.1.13. The fuel thermostat
      8.1.14. The hydrovalve case
      8.1.15. A cable of gas/lever throttle заслонки (ДД)
      8.1.16. A cable of management of gas (ДД)
   + 8.2. Ignition system (petrol engines)
   + 8.3. System of prestarting heating (diesel engines)
   + 8.4. System of release of the fulfilled gases
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, a steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice

8.1.3. The accumulator

8.1.3.1. Check and a gymnastics
THE GENERAL DATA

It is recommended to check specific density of electrolit each three months for definition of gymnastics of the accumulator.
 
Air temperature above 25 ° With
Air temperature more low 25 ° With
The accumulator is completely charged
1,210 – 1,230
1,270 – 1,290
The accumulator is charged on 70 %
1,170 – 1,190
1,230 – 1,250
The accumulator is discharged
1,050 – 1,070
1,110 – 1,130

Check up electrolit density in each section of the accumulator. If the specific density of electrolit between sections differs more, than on 0,040, it is necessary to replace the accumulator.

THE ACCUMULATOR WHICH IS NOT DEMANDING MAINTENANCE SERVICE

The accumulator does not demand доливки electrolit and check of its density. For check of a condition of the accumulator the indicator serves.

The gymnastics of this type of accumulators demand more time, than gymnastics of usual accumulators. The gymnastics are necessary for spending at pressure to 13,9–14,9 Volt, the gymnastics current should not exceed 25 Amperes.

THE USUAL ACCUMULATOR AND THE ACCUMULATOR DEMANDING SMALL MAINTENANCE SERVICE

Force зарядного a current should make 10 % from accumulator capacity. To continue gymnastics it is necessary until the specific density of electrolit will not raise within 4 hours.

Also for accumulator gymnastics it is possible to use зарядное the device for continuous additional charge of the accumulator with a current strength of gymnastics of 1,5 Amperes. Such зарядное the device can be left included for the night.


On the main page